answersLogoWhite

0


Best Answer

Remove the vacuum hose from the oxygen sensor. Remove the oxygen sensor retaining screws. Reverse the process to install the new oxygen sensor.

User Avatar

Wiki User

9y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Ford Fiesta oxygen sensor replacement
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What are symptoms of oxygen sensor fault on Ford Fiesta?

possible symptoms are the engine warning light will be on


Where is the temp sensor on a Ford Fiesta 1300 1997?

where can i find the temperture sensor on a ford fiesta 1997


Is there a Hugo sensor in a Ford Fiesta engine?

Yes


Where are the Bank 1 Sensor 1 oxygen sensor on a 1998 Ford Explorer?

Where are the Bank 1 Sensor 1 oxygen sensor on a 1998 ford explorer?


How much would it cost to replace abs sensor on a Ford Fiesta?

60million


How do you change an oxygen sensor on a 1981 ford ltd crown Victoria?

The 1981 Ford Crown Victoria does not have an Oxygen sensor.


Location of map sensor on 2003 fiesta 1.4 tdci?

hai my car is ford fiesta zetec 2003 5door ,in my cay o2 sensor have fault .can you tell me how many o2 sensor are there and were is location


Where to buy rear door replacement quarter glass for a 1996 Ford Fiesta?

Salvage yard?


Where is the heated oxygen sensor 1996 Ford Taurus?

The 1996 Ford Taurus heated oxygen sensor can be found behind the dashboard on the passenger side of the passenger compartment. The oxygen sensor should be labeled as such.


Where is the oxygen sensor on a 1997 Ford Aerostar?

The 1997 Ford Aerostar oxygen sensor is screwed into the exhaust pipe. It is about even with the rear of the oil pan.


Diagram of oxygen sensor for 2000 ford focus?

A 2000 Ford Focus oxygen sensor diagram can be obtained from most Ford dealerships. The diagram can also be found in most Ford repair manuals.


How to replace oxygen sensor on a 2002 ford explorer xlt?

To replace the oxygen sensor disconnect the oxygen sensor electrical connector. Use an oxygen sensor socket to remove the sensor. spray the sensor with penetration oil if it is difficult to loosen. install in reverse.