answersLogoWhite

0


Best Answer

vcc-voltage collector to collector

vdd- voltage deran to deran

ttl- transister transister logic

cmos - complementary metal oxide same conductor

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Full form of vcc and vdd in TTL and CMOS?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What Vcv Stands For in Electronics?

if you are reffering to Vcc than it means- It is the positive power supply used for TTL gates it is nothing but simple dc power supply. if we use CMOS than we use Vdd for indicating power supply these are method for indicating power supply.


What is conversion of TTl voltage level to MOS level?

A: TTL Vcc is fixed at 5v +/- .5 volts while MOS can be run at higher Vcc like 12 volts therefore there is a compatibility problem and a converter must be installed between this family of gates to make them compatible with each other. So a converter will do just that translate a TTL level to a MOS level


What is voltage level of ttl?

Standard TTL (which stands for Transistor-Transistor Logic) circuits operate on a 5V power supply. The typical level for a logical "0" is between 0V and 0.8V, and the typical level for a logal "1" is somewhere between 2.2V and 5V. Typically, a value little lower than Vcc (power source voltage) is used; in case of a 5V supply, this is usually around 4.5V, but TTL devices are built to withstand full Vcc as input, just in case.


Why CMOS connected to VDD and NMOS to Vcc?

Error on schematic. All MOS is powered by Vdd and/or Vss (drain/source). Only bipolar is powered by Vcc and/or Vee (collector/emitter).


Who want buy vcc. me sell vcc please contact me at prakashsagita-ymail-com?

Buy VCC - Shopvcc.com


Why does vcc voltage called vcc?

I believe that Vcc stands for Voltage Common Collector. This is because the voltage is hooked up to the collector of the transistor.


What should be done with the unused inputs of a TTL integrated circuit?

Unused ttl inputs would normally default to logic 1 if left floating. but these inputs could act as antennas under certain conditions and they could pick up noise which can cause the circuit to malfunction. it is better to tie unused inputs to Vcc through a 1k resistor (74LS, 74XX etc) or simply return the inputs to ground. for most other ttl families, the 1k resistor might not be required.- Stan (Nigeria)


What does Vcc stand for on a SIM card?

VCC is an electronics designation that refers to voltage from a power supply connected to the "collector" terminal of a bipolar transistor. In an NPN bipolar junction transistor, it would be +VCC, while in a PNP transistor, it would be VCC More about sim card .... https:// telecom-hyb.blogspot. com/2017/09/what-is-sim-card.html


Where can you buy vcc or virtual credit cards to verify your PayPal account?

Hello there, I know a great place where you can find paypal vcc at a cheap rate. I bought several vcc from them. They delivered Instant, and working really fine. So I think that website can be helpful for you. Here is name of the website BESTVCCSERVICE. COM


What s linear inverting amplifier?

An inverting amplifier having linear output characteristics is disclosed which includes additional n-channel and p-channel transistors coupled to a classic CMOS inverter circuit. The linear transfer characteristic is achieved with nearly full dynamic Vcc range. The invented amplifier yields a linear transfer characteristic by controlling the dimension ratios between each of the transistors. The wide dynamic range, wide bandwidth and low output impedance make the circuit well-suited for use as an output stage of a CMOS operational amplifier. Source - http://www.freepatentsonline.com/5113150.html


Does endless have a VCC CV pattern?

yes


Is conflict a vcc cv word?

Yes. The word "conflict" has the vowel-consonant-consonant-vowel-consonant (VCCVC) pattern.