to hold the light bulb at a vertical angel and stop it from falling off.
The function of a lamp is to give light while minimizing the risk of anything around it catching fire.
dsghj
The metal tip of a light bulb has to make contact with the bottom of the lamp holder's middle center contact to operate.
The power rating is printed on the lamp holder, expressed in watts. As power describes the rate of energy consumption, you need to convert the number of watts into kilowatts (divide by 1000) and multiply this figure by the time for which the lamp is in use (expressed in hours) -this will tell you the number of kilowatt hours of energy used.
Lamp have required high rating to glow & have a specific luminus area.exa-table lamp,florucent lamp,sodium vapur lamp,BUT but bulb have no required rating exa- halogin bulb
what the function of lamp holder
what the function of lamp holder
A device for holding a lamp.
A lamp holder that turns on from a wall light switch not a switch on the device.
Your question does not supply enough information. There would be no reason to have a 'jumper' on a lamp holder under normal conditions and I don't know what "the other terminal" of a lamp holder is.
what is surface type lamp holder
A lamp holder is a device used to secure a light bulb or lamp in place, typically providing electrical connections for the bulb. It is commonly found in light fixtures and lamps to hold the bulb securely and allow it to be powered.
The heat lamp's heat will travel to the holder and it will be damaged, melt, or cause a slight fire!
what does bc lamt stand for
From the rear trunk, remove carpet strip behind the lamp by unscrewing 2 plastic discs. You can then see the black plastic bulb holder assembly. Pull down on the black plastic tab on the lamp holder to release it. The complete lamp holder can then be gently guided out of the rear lamp assembly.
to house the lamp
The function of a lamp is to give light while minimizing the risk of anything around it catching fire.