0
The switch is located on the top left side of the column just under the dash. It is operated by a rod that runs down to the switch from the lever. You must remove any lower covers there is normally one, but I do not know if you have a conversion van where as something else may be mounted. Under the cover there will be two studs with nuts, one on each side. There is also a light cable that goes from a clip to your shift indicator. Mark the location of the clip and remove by pushing it back and off. Do not lower the column until you have located and dis connected this cable, or you will snap off the plastic sheave the cable runs on, and the indicator will not work again. Now lower the column by removing the nuts. You should be able to see the switch now, it is of a round design. Unplug the wiring harness from the switch. Remove the screws that mount it (7mm I think). Install new switch and adjust by operating the lever making sure switch works as it should, if not slide it on the mounting screw slots until it functions properly. Now just put it back together. Need more help contact me through my board and I will try to help.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you change high beam on 1992 silverado?
it has a switch under the steering column
How do you change your high beam switch on a 1986 Mercury Topaz?
Just take the covers off the steering column, switch is there.
How do you change the ignition switch in a 1985 Monte Carlo?
You're going to have to unbolt the steering column and drop it down. The ignition switch will be on the top of the column along with your high beam switch. Unbolt the switch then unplug it.
What would cause your 2002 Monte Carlo to have high beam headlamps only and no low beam?
Probably the high beam switch in the steering column is bad.
Where is the highlow beam relay switch?
Low to high beam is the lever on the steering column, if there is a problem, look there first...
Where is the ignition switch on a firebird?
On the top side of the steering column about halfway down, the high beam/low beam headlight switch should be bolted to the column right beside it. Inside the vehicle.
Where is the high-low beam relay switch in 1992 Jeep Cherokee?
I believe the dimmer switch is in the steering wheel column.
How do you bypass the high beam low beam switch on the steering column of a Chrysler intrepid 1994?
You don't. Why would you want to. You repair what is broken.
How do you change high beam switch on 1989 Pontiac trans am gta?
The steering wheel will have to come off and then the top cover on the column has to come off and then you will be able to see how the switch comes out, just a few screws.
Where is high beam switch location on 1977 corvette?
It is on the signal light switch. Pulling it toward you will change from High to Low beam lights and vice-versa 7T77T7
Where is the high beam switch on a 1967 volkswagen bug?
The high beam switch is on the reverse of the turn signal switch arm
1988 crown Victoria all headlights go out on low beam but work on high beam?
As silly as it sounds, both low beam bulbs are most likely blown. If not, check switch in the steering column.
