Step 1 - Remove the plastic trim around handbrake by pulling it up from the rear it will unclip.
Step 2 - There is a 10mm nut you can turn this to adjust the handbrake. A good idea is to park on a flat and then see if the car can be easily pushed with the handbrake released.
Step 3 Once the handbrake is adjusted to the correct amount replace the trim and firmly push down on it so it clips back into place.
If you find this method does not improve your hand brakes effectiveness you will need to get you rear calipers checked as they may be fualty.
There is none!
Try Checking the Brake Fluid Level. And Check the Fluid Level sensors Contacts it may be corroded
1200
New VW Polo for EU market is made in Bratislava, Slovakia.
handbrake adjustment on cougar
How do you turn off airbag in vw polo 1999
Can someone advise how i fit an elecrtric pump to a vw polo twist?
Remove the plastic cover from the puma handbrake. There is an adjustment nut under the cover that tightens up the brake.
on most cars you can take off the complete handle and inside of the handle is the braking mechanism there is a screw with a cable attached to it in various fashions you tighten or loosen that screw until your brake is to your preference
1.4liter polo Playa 2002
Spain
It does.