Chevy Blazer
Chevy S-10
Chevy Blazer S-10

How and where do you change the starter on a 1993 Chevy Blazer?

282930

Top Answer
User Avatar
Wiki User
2008-06-24 19:39:05
2008-06-24 19:39:05

follow the wires that come off the positive battery terminal the starter has two bolts to take off then the starter comes off then unhook the power wires from starter

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Where is the horn located on a 1993 chevy blazer

User Avatar

remote starter?? No remote starter car is 1993 Chevy blazer (truck)

User Avatar

if you have to ask this question, then you shouldn't attempt to change them...

User Avatar

You will have to remove the transmission pan that is on the bottom of the transmission to drain the fluid.

User Avatar

The 1993 Chevy Camaro starter can be found on the right hand side of the engine. You can follow the positive at three cable directly to the starter.

User Avatar

A blown fuse can make your dashboard lights to not work in your 1993 Chevy Blazer Tahoe. A burned out bulb can also cause this.

User Avatar

Begin by removing the positive cable from your 1993 Chevy Corsica battery. Remove the cables on the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.

User Avatar

The starter is bolted to the engine by two bolts which makes it very easy to change, just remove the bolts and drop the starter down until you can remove the wires from it, it is a good idea to remove the negative battery cable before starting the job to prevent arcing the wires to ground.

User Avatar

which fuse is for the fuel pump in a 1993 chevy s10 blazer

User Avatar

Remove the positive battery cable from your 1993 Chevy Cheyenne battery. Remove the two cables from the front of the starter. Remove the three starter retaining bolts. Reverse the process to install the new starter.

User Avatar

how do you change the starter on 93 525i BMW

User Avatar

3-4 wires [fusible links] comming off that positive post on the starter they are usually pink or yellow.

User Avatar

The 1993 Chevy S 10 Blazer IAT sensor can be found on the top of the transmission. The IAT sensor will be near the front of the transmission.

User Avatar

Is there a way to bypass the ECM in a 1993 chevy s10 4.3 vortec

User Avatar

Replace it with a new one, there is no repairing it.

User Avatar

Begin by removing the positive cable from your 1993 Chevy Camaro battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. The starter will come off.

User Avatar

There is no spark plug cap located on the 1993 Chevy Blazer. The spark plug gap for this vehicle varies depending on the type of spark plug that is used. The OEM spark plug gap for this year is 0.040.

User Avatar

Yes, this is an acceptable weight for your Blazer. Do not fall for the 3,000 mile oil change myth. That is a waste of oil and money. Change your oil according to the manufactures recommendations. On your Blazer that is probably 5,000 miles. Use a quality filter such as an AC/Delco, Purolator, or Wix.

User Avatar

by separating the lower balljoint and sway bar on that side

User Avatar

Under the vehicle, bolted to the frame on the driver's side


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.