0
Pull up and down until it loosens. Release the cloth under neath the zipper, and then pull until it becomes loose.
If the zipper teeth are damaged or missing, the entire zipper must be replaced. If the zipper just keeps popping open, you probably just need to replace the slide or "pull" Look on the back side of the slide and there will be a number and/or letter. Number denotes size (5, 7 or 10 is most common for coats or jackets) and the letter usually tells what style (plastic, metal, coil etc.) Cobbler shops usually have replacement slides for most zippers and they can usually replace it while you wait. Costs run $5 to $10 installed, (versus $40 to $80 for an entire new zipper!) If you can buy just the slide from a shop, it's very easy to install 90% of jacket zipper slides. At the top of the zipper will be "stops" or little tiny U-shaped pieces of metal crimped on above the top tooth of the zipper. They're there to prevent you from pulling the slide all the way off, hence "stops". Carefully remove it by opening it slightly using a pair of dikes or side cuts...wirecutters to the layman. Just use the sharp edge to get in between and squeeze lightly. The stop should open just a bit. Carefully remove it and put it somewhere nearby, DONT LOOSE IT! You only need to take off the stop that's on the same side as the pull (slide). Now pull the original slide all the way off the top, you might have to twist it a little, but it should come right off. Now take the new slide and work it back on, from the top down, on the same zipper track you just took the old one off. Grab the tab of the slide and twist back and forth until it drops freely onto the zipper teeth and falls to the bottom. Now take the "stop" and crimp it back on and your done. If you got the right slide it will zip right up tight just like a new jacket.
As a former cobbler myself that did a lot of jacket repairs, I would say 7 out of 10 bad zippers were just the slides. They wear out much quicker than the teeth and then cannot mesh both sides together fully. Support your local cobbler!! You'd be amazed at what they can create and repair. And in this economy "Repair and Save!"
What else can I help you with?
How do you fix a zipper that has split open?
You can fix a zipper that has split open by clamping it with a pliers
How can I fix a zipper on a backpack?
To fix a zipper on a backpack, you can try lubricating the zipper with soap, wax, or a specialized zipper lubricant. If that doesn't work, you may need to replace the zipper slider or the entire zipper. You can find replacement parts at a craft or sewing store, or take it to a professional for repair.
What type of plastic is a plastic zipper made of?
Usually nylon.
How can I fix a zipper on my backpack?
To fix a zipper on your backpack, try lubricating the zipper with soap, wax, or a specialized zipper lubricant. If that doesn't work, check for any obstructions in the zipper teeth and gently realign them. If the zipper is still stuck, consider replacing it with a new zipper or seeking help from a professional tailor or repair service.
How to fix a warped moulding?
replace it
Where can one purchase plastic zipper bags?
Plastic zipper bags can be purchased at most supermarkets, department stores, office supply stores, and online retailers. They are commonly found in the food storage or organization section of stores.
What are vislon zippers?
A zipper style made by YKK. It's a rugged plastic zipper with large teeth.
How can I fix a stuck zipper on my backpack?
To fix a stuck zipper on your backpack, try rubbing a bar of soap or a pencil along the teeth of the zipper to lubricate it. Gently wiggle the zipper back and forth to loosen it. If that doesn't work, you can also try using a pair of pliers to carefully pull the zipper back into place.
How can I fix a backpack zipper that is stuck or broken?
To fix a stuck or broken backpack zipper, try applying a lubricant like soap or wax to the zipper teeth. Gently wiggle the zipper back and forth to loosen it. If the zipper is still stuck, carefully use pliers to pull the slider along the teeth. If the zipper is broken, you may need to replace it with a new zipper or take it to a professional for repair.
Is there a way to fix a zipper that is stuck on a backpack?
Yes, there are a few methods to try to fix a stuck zipper on a backpack. You can try using a lubricant like soap or wax, gently pulling on the fabric around the zipper, or using a pair of pliers to carefully adjust the teeth of the zipper.
How can I fix a stuck backpack zipper?
To fix a stuck backpack zipper, try applying a lubricant like soap or wax to the zipper teeth. Gently wiggle the zipper back and forth to loosen it. If that doesn't work, use a pair of pliers to carefully pull the zipper pull tab in the opposite direction of the stuck area. Be patient and avoid forcing the zipper to prevent damage.
How can I fix a stuck zipper on a backpack?
To fix a stuck zipper on a backpack, try applying a lubricant like soap, candle wax, or a graphite pencil to the teeth of the zipper. Gently work the zipper back and forth to loosen it. If that doesn't work, you can also try using pliers to carefully pull the teeth apart. Be cautious not to force the zipper, as this could damage it further.
