drill peep holes first.. But drill shallow. After best guess a 1/4" pilot hole first then 3/8' the pump assembly is located from left to right, in the rear m iddle of the hump i did this to my 93 ta and it takes a long time due to the tank being so close to the body of the car. don't blow yourself up
To change the reverse lights on a Pontiac Sunfire you need to locate it on the left side of the transaxle. Then, unplug the electric connector and remove the switch along with the socket.
locate your fuel tank....fuel system....if need be to remove the seat, do it!
To change the dashboard lights in a 1994 Pontiac Sunbird, begin by removing the dashboard cover. Use a screwdriver to unscrew any fasteners holding the cover in place and carefully lift it off. Once exposed, locate the bulb sockets for the dashboard lights, twist them counterclockwise to remove, and replace the old bulbs with new ones. Finally, reassemble the dashboard cover by reversing the removal steps.
I've never had to change mine, but it's an in-line filter located near the gas tank.
The easiest part youll ever change. Do it yourself. locate therm Unscrew cap and drop it in screw cap back on shouldnt cost you more than 15 bucks.
To find the code on a Pontiac Vibe radio, first, turn on the ignition and the radio. If the radio displays "LOCK" or "CODE," you will need to locate the serial number, which is usually found on the radio itself. You can often retrieve it by removing the radio from the dashboard. Once you have the serial number, you can contact a Pontiac dealership or check the owner’s manual to obtain the unlock code.
look for it
In the 1993 Pontiac Grand Am GT, the voltage regulator is typically integrated into the alternator. To access it, you would need to locate the alternator, which is mounted on the engine, usually on the front passenger side. If the regulator needs replacement, it often requires removing the entire alternator from the vehicle.
where to locate heater fuses for a 2001 grand prix gt
locate blend door actuator for 1997 pontiac bonneville se
To change the heater core on a Pontiac Aztek, locate the heater core on the firewall, passenger side of the vehicle. Remove bolts on the firewall and the clamps on the hoses. Take out the old heater core and replace with new. Tighten bolts and hose clamps. Then check to make sure the radiator is full of antifreeze.
no transponder on '94 model