You can buy a "pipe hammer arrestor" at your local home improvement center. You will need two - one each for hot and cold. Basically, it is a piece of pipe that uses the air trapped in the pipe to absorb the shock when the valves close quickly.
It depends on where it is dripping. The spinning cycle of the machine might be causing the pipes to loosen up. You might want to check out the pipes if they are loose.
No reason why not - simply run the machine 'empty' (with no washing in) - and follow the instructions on the packaging. It's a good idea - especially if you're in a 'hard water' area. Performing periodic cleaning of an empty machine will prolong its life.
Washing machines are connected to your mains water supply so either there is a problem with your water supply in as much as it is continually leaking when it's not supposed to be in use, or, more likely, there is a blockage in the machine or the water pipes immediately surrounding it which is causing water to flood back out of the machine. It's usually a small item of clothing like a sock (or a collection of them) that has worked its way out of the machine via that gap at the front of the drum just next to the door, and is now blocking your pipes. You may find water bubbling back out of your sinks and bath, depending on their proximity to the washing machine. You need a plumber, quick!
could be air in the pipes. Makes a banging sound until the air is released. Look for a valve
air in the water lines causes banging and whistles/screams. Turn off main water, turn on the faucet, turn main water back on, and it should force the air out.
It is actually required in model codes as it preheats the water to the machine
Sounds to me like you have a clog in one of your pipes. This causes water from the washing machine to drain into other pipes instead of going down the main line properly. Check the bathtub when the washing machine is draining... they're notorious for filling with old yicky washing machine water! The clog can possibly be in a line ion the house, or possibly be caused by roots in the main line. Sounds like it's time to hire a plumber! Good luck!!
It depends on where it is dripping. The spinning cycle of the machine might be causing the pipes to loosen up. You might want to check out the pipes if they are loose.
Raise the room temperature, or place a hot water bottle inside the machine, and allow the ice to melt in the pipes. Hopefully, the plastic pipes will take the expansion from the ice and not spring a leak.
It doesn't pump the water in, where the hoses attach to the washing machine is a valve that opens and lets the water in. The pressure in the line forces the water in the same way it does when you turn on a faucet.
It would burn out the pump motor after a while. I don't recommend doing it.
Yes, the same pipes that supply drinking water to your sink also supply water to your bathtub, toilet, washing machine, exterior spigots, etc.
No reason why not - simply run the machine 'empty' (with no washing in) - and follow the instructions on the packaging. It's a good idea - especially if you're in a 'hard water' area. Performing periodic cleaning of an empty machine will prolong its life.
See if there is something stuck in the pipes that is clogging it up and causing this to happen.
Backflow from the sewer or drain pipes.
You follow the instructions that came with the machine. You connect up the cold and hot water feed pipes as instructed and then plug it into the mains. If it a new machine you may also have to remove the packing stabilisers first.
Ask This Old House - 2002 Banging Pipes Installing Fiberglass Door 7-19 was released on: USA: February 2009