The rock will react by opening up in the center. That is only if it works. Besides, a rock will most likely NOT react to the acid because it is too strong and solid.
Hydrochloric Acid- Calcite will fizz.
You could tell an older rock from a younger rock by looking at it because the older rock isochron would have a steeper slope.
One would be a scratch test. The quartzite is much harder than the marble. Another test would be the use of dilute hydrochloric acid, which will cause decomposition of the calcite minerals forming the marble.
a rock is never alive
sedimentary rock is a multiple of layers
We could tell the solution was an acid by reading the pH scale.
Hydrochloric Acid- Calcite will fizz.
You could tell an older rock from a younger rock by looking at it because the older rock isochron would have a steeper slope.
Vinegar reacts more slowly with zinc and marble chips because it has a lower concentration of hydrogen ions compared to hydrochloric acid. Hydrochloric acid is a strong acid and dissociates completely in water to produce more hydrogen ions, leading to a faster reaction. Additionally, the presence of chloride ions in hydrochloric acid can also enhance the reaction rate.
It is not so you cannot ever tell.
When magnesium reacts with nitric acid, it undergoes a single displacement reaction where magnesium displaces hydrogen from the nitric acid, forming magnesium nitrate and hydrogen gas. The balanced chemical equation for this reaction is: Mg + 2HNO3 → Mg(NO3)2 + H2. The magnesium nitrate formed is a soluble salt, while the hydrogen gas is released as a byproduct.
water doesn't burn
Any acid (vinegar, lemon juice etc) will start to eat away the rock and it will fizz a little.
One would be a scratch test. The quartzite is much harder than the marble. Another test would be the use of dilute hydrochloric acid, which will cause decomposition of the calcite minerals forming the marble.
Dilute hydrochloric acid can be used to distinguish quartz from marble by conducting a simple acid test. When a drop of dilute hydrochloric acid is applied to quartz, there will be no visible reaction since quartz is resistant to acid. On the other hand, if the acid is applied to marble, it will fizz or bubble due to the reaction with the calcium carbonate in the marble, indicating that the rock is marble.
When excess hydrochloric acid has been added to an evaporating dish with magnesium, you will observe bubbling and fizzing as the magnesium reacts with the acid. Once all the magnesium has been consumed in the reaction, no more bubbles will be produced, indicating that excess acid is present.
The acid test is used to determine if a mineral contains carbonate minerals. When a mineral fizzes or reacts with acid, it indicates the presence of carbonate minerals such as calcite or dolomite. This test helps mineralogists identify and distinguish between different minerals.