On the gearshifter side of the bike, in front of the rear turn signal is a lock and loop thingy. That is for locking the helmet. But, if you turn the key as though you are going to lock the helmet, and push a lever next to it, the seat will unlock. I believe you move the lever towards the front of the bike. The key will stay in the lock when you are in this mode. Give the seat a pull on the passenger strap. The seat will pop off. Put back on by looking under the seat when reinstalling it. You'll put it back on by putting the drivers end of the seat first, then the passenger part.
There is a storage compartment under the back of the bike, accessible by taking off the seat.
Carl
I've had one of those since 1991. Actually you turn the key as though you were going to unlock the helmet. There is a tab beside the helmet loop and you push that down. While holding that down pull up and back on the seat strap. You can remove the key once the seat is removed.
Edward
Remove rear seat and panel underneath seat. How do I remove rear seat?!?!
To remove the seat from a 1992 Honda Nighthawk 250cc, locate the seat release mechanism, which is typically a bolt or two at the back of the seat. Use a suitable wrench or socket to unscrew these bolts. Once they are removed, gently lift the rear of the seat and slide it backward to detach it from the mounting points. Be sure to check for any additional fasteners if the seat does not come off easily.
ya no problem
Remove the seat and you will see a cover with 3 small bolts with and opening facing backwards. Take the bolts out and pull up on the cover and the filter is under it.
Bad needle and seat Throttle cable misadjusted
how do I remove the front seat from a 1991 fatboy
The 2006 Honda CBF 250 seat is held in place by four retaining bolts. Remove the retaining bolts to remove the seat.
The pump is located underneath the rear seat, to remove it first you must lift the back seat and then remove the cover of the pump that is fastened with 4 bolts
Essentially on the left rear of the bike in front of the rear signal light, there is a lock with a loop under it and a tab next to it. This operates both the helmet lock and the seat removal. Insert and turn key. push down on tab. While holding tab down pull up and back on seat with strap. Seat pops off. To replace you are going to have to line up hooks on underside of seat with loops in seat area then push forward and down until it clicks.
how to remove front passenger seat of 1996 Honda Civic EX 2 door coupe
To remove the back seat from a 1997 Honda Odyssey the seat locks need to be opened. When the clips are unlocked the seat will be able to be lifted up and removed from the vehicle.
Remove two bolts at the rear of the seat, pull up and backwards.