0
take the bolts out of it
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the Thermostat in a 2002 Chevrolet Impala 3.4?
It's underneath the throttle body on the engine, take the big rubber hose off the air cleaner box and the other end attaches to the throttle body.
Where is the Idle Air Control Valve on 2002 trailblazer?
The Trailblazer has an electronic throttle (drive by wire). There is no IAC valve, it is built into the throttle body. Remove and clean the entire throttle body.
Where is the mass air flow sensor on a 2002 impala?
Between the Engine Air Cleaner/Filter Housing and the Air Inlet Tube of the throttle Body.....
How do you replace a throttle body Chevy Trailblazer?
How do you replace a throttle body on a trailblazer 2002
Where is the Mass Air Flow Sensor located on a 3.8 2002 impala?
The MAF Sensor is between (& attached to) the Air Filter Housing and the Air Intake Duct of the Throttle Body...
Where is the throttle position sensor you a Chevrolet Malibu 2002?
on side of throttle body at throttle plate.
How do you clean throttle body on a Chevy blazer 2002?
Purchase a can of throttle body cleaner and follow the directions on the can.
Where is the idle air control valve on a 2002 Mitsubishi Galant?
The IAC should be directly below the throttle body. Remove the air cleaner duct from the throttle body and air cleaner housing. You'll see a component with a 6 wire connector screwed to the bottom of the throttle body assembly.
How do i fix a Coolant leak under the throttle body?
You will need to remove the throttle body and replace the throttle body gasket. The throttle body gasket can be purchased at most auto-parts stores.
Throttle body injectors not firing on 1990 impala?
Need to replace ingnetion module in the distributor.
Where is the idle air control valve located on a 2001 Chevrolet Impala?
It is located on the throttle body.
Where is the Throttle Position Sensor on a 1990 Ford Bronco?
it is located in the throttle body. On the bottem. You need to remove the air filter hoses, remove the 4 bolts to the throttle body and then 2 screws to remove the tps.
