use a vag com or just unplug and replug
How to reset transaxle on 95 eagle vision
It doesn't have a body control module.
Were is the body control module located on 02 Saturn L 200
Resetting the PCM, or power train control module, requires access to the engine bay. To reset the control module simply unplug the negative battery cable from the battery for five seconds.
The air bad "control module" is located under the front dash, behind the stereo. You will likely need to reset or replace the control module if your SRS (Supplemental Restraint System) light stays on. The air bad "control module" is located under the front dash, behind the stereo. You will likely need to reset or replace the control module if your SRS (Supplemental Restraint System) light stays on. The air bad "control module" is located under the front dash, behind the stereo. You will likely need to reset or replace the control module if your SRS (Supplemental Restraint System) light stays on.
Scan tool or battery disconnect.
Some early s-10 Blazers and jimmys had an electronic shift pattern . There is a small plate on the side of transmission . If you remove the cover there is a reset switch that can be reset by taking a ink pen or pencil and press the switch to reset . If it is a newer model there is a shift control module , hold on to your wallet these are extremely high priced . Hope this helps . Rick
still have p0715 still after cganhe the parts / you think is this transmission module \
no "reset switch" on these cars the powertrain control module controls the fuelpump via a relay
unplug the control module fuse and disconnect the battery for 5 minutes.
The engine control module "learns" how to set the idle speed. When you disconnect the battery the engine control module loses that memory and it has to be reset. To regain the setting drive the car for several miles at moderate speeds and it is reset.
The reset button is not in the changer itself. It is in the RM Module (AKA hideaway unit) where the wired control (RM X87) is connected.