Check your maintenance manual. It's in there.
on the upper left side of the guages there is a button labeled "reset". with the key off hold the button in, then turn the key on. the light should flash for a few seconds then turn off.
To reset the maintenance light on a 2007 Toyota 4Runner, start by turning the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. After that, turn the ignition off and then start the engine to ensure the maintenance light is reset. If done correctly, the light should no longer be illuminated.
fill all 5! tires to the proper pressure, even the spare will transmit and trip the light
To reset the maintenance reminder on a 2017 Toyota 4Runner, start by turning the ignition switch to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. Then, turn the ignition off and start the engine to ensure the maintenance light has been reset. If done correctly, the maintenance reminder should no longer be displayed.
To reset the VSC (Vehicle Stability Control) warning light on a Toyota 4Runner, first ensure that the issue triggering the light has been resolved. Then, turn the ignition to the "ON" position without starting the engine. Press the gas pedal fully to the floor and release it three times within five seconds. Finally, turn the ignition off and then start the engine to see if the warning light has cleared. If the light remains on, you may need to use a diagnostic scanner to reset it or consult a professional mechanic.
Yes, there is. For instance, if the engine does require some attention.
How do you reset the Airbag warning light on a 1995 Toyota Avalon?
The brake light is controlled by a relay switch. If the relay switch is bad the brake lights will stay on. The brake light switch simply plugs in and out. Unplug the brake light switch until you can replace it.
have you tried pulling the EFI fuse
Brake system warning light.....
Turn the 4Runner on, make sure that you are looking at the "odometer" miles and not the "Trip" miles. Turn the 4Runner off, hold the "reset" button, turn the 4Runner On and the "MAINT" light will blink 3 times. Release the "reset" button and the light will turn off. This worked great for me but the light flashed 5 times then went off. 2007 SR5 4WD 16,000 miles recently purchased from dealer hopefully there is nothing else wrong/ FYI the manual told me that the maint light is for oil change.