If there is a black wire going from the outlet to the switch and the other side of the switch goes back to the outlet then just cut these wires and connect supply wire directly to outlet. If the supply goes to the switch first, disconnect from switch and connect the two wires with a wire-nut. Some situations only switch one of the two outlets in a duplex device. Do the same thing, but also replace the outlet since the strapping between both outlets has been removed.
On what? IS this an outlet or a switch?
Plug a lamp into a working socket of an outlet to ensure the lamp works. Then turn off the switch and plug lamp into all outlet sockets, top and bottom outlets until the lamp doesn't light. Then turn on the switch and the lamp should light. Often a switch in a bedroom is only connected to one socket in a duplex outlet. It is possible to remove a jumper in an outlet to isolate the sockets for just this purpose. Often an electrician will install the outlet upside down (The third prong pointing up, to identify the outlet.
A single pole switch controls a light or outlet at one location. A 3 way switch controls a light or outlet from 2 locations.
switch socket outlet
If you are asking can you put a device, controlled by a switch, using a connection with an outlet, the answer is yes. The caveat is that whatever you add must stay within the amperage rating of the controlling fuse or breaker.
If there is a black wire going from the outlet to the switch and the other side of the switch goes back to the outlet then just cut these wires and connect supply wire directly to outlet. If the supply goes to the switch first, disconnect from switch and connect the two wires with a wire-nut. Some situations only switch one of the two outlets in a duplex device. Do the same thing, but also replace the outlet since the strapping between both outlets has been removed.
No, that is not unsafe.
If I am reading your question right, you can do this. Just parallel the outlets to the device already switched by the 3-way switches. The outlets will turn off and on by the switches. Watch that you do not overload the switches or the circuit.
Could be a loose connection somewhere, or a bad switch, or a bad outlet.
On what? IS this an outlet or a switch?
You need to run a wire from the existing power source to switch to switch to switch to outlet.
yes
Yes, just make sure it is a 220 volt switch.
Plug a lamp into a working socket of an outlet to ensure the lamp works. Then turn off the switch and plug lamp into all outlet sockets, top and bottom outlets until the lamp doesn't light. Then turn on the switch and the lamp should light. Often a switch in a bedroom is only connected to one socket in a duplex outlet. It is possible to remove a jumper in an outlet to isolate the sockets for just this purpose. Often an electrician will install the outlet upside down (The third prong pointing up, to identify the outlet.
A single pole switch controls a light or outlet at one location. A 3 way switch controls a light or outlet from 2 locations.
Home depot sells RF switches whereby if the fan is connected to the transmitter. It can be controlled by as far as 5 meters i believe In my SPA i have this device for safety. switch here get turn on there