0
you can't its computer controlled, unlike the old carburetors with an idle air mixture screw to adjust, its set by the factory and you can't screw with it
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you adjust a mercury 150 outboard boat motor idle?
You adjust idle with idle timing
How do you adjust idle in the Mitsubishi diamante?
Adjust idle on Mitsubishi diamante
How do you adjust the idle speed on a 2001 Subaru Forester and what should the idle speed be?
how to adjust idle on 2001 legacy
How do you adjust the idle speed on a 1993 Honda Accord?
On a 90-93 Honda Accord you can adjust the idle with a screwdriver. On the throttle body there is a screw on the top left above the intake duct. Just adjust until idle is in correct range (usually around 700)
Where is the idle control valve on a 1995 Maxima?
The idle control valve for your 1995 Nissan Maxima can be found on top of the engine. The idle control valve will be attached to the back of the injector fuel pump.
How do you adjust idle speed for Toyota supra?
you can adjust it via the idle control valve.
How do you adjust the idle speed on 93 accord?
To adjust the idle speed on a 1993 Honda Accord, you will need to locate the adjustment screw which is located on the throttle body. This can stick at times due to obstructions. Once the screw is located, apply carb cleaner to loosen up any debris which may be causing the idle speed to be off.
How do you adjust idle on 2008 mitsubishi lancer es?
you cant adjust your idle, it is computer controlled
How do you adjust the tps throttle positioning sensor the iac idle air control valve and the fuel trim on a 93 GMC Sanoma w4.3 vortec?
you can't
How do you adjust the idle control valve on a 1988 Caprice?
You do not adjust the Idle Air Control as it is controlled by the computor.
Where is the Location of the modulator valve on a 93 Nissan Maxima?
where is the location of the modulator on Nissan maxima transmission
How do you adjust the idle on 1998 Toyota Avalon?
You dont adjust the Idle disconnect the battery for 10 mins and reconnect and the computer should relearn it idle .
