Remove 2 screws from the back holding the top lid, then slide the lid backwards and lift the lid.
Attach a rocket to it.
It should just have a slide clip that holds it in.
The measurements make for a very steep slide with a gradient of nearly 3.3! Anyway, given these measurements, the bottom of the slide needs to be attached approx 25.6 inches from the bottom of the tower.
In the passenger compartment you find the filter in the bottom of the "heater box". slide the lock of the lid aside and remove the lid. then you just pull out the old filter, put in the new and replace the lid.
Usually yes. Especially for snakes, they normally have a lid with little slits in which you attach the lock to.
The installation guide says that no special tools are required. You just assemble the frame, slide it on top of your TV and attach using straps.
you need to attach fregly's left over fish sticks that you get in the fun house after you use the oily sunblock on the slide to free Rowley.
A snow sledge can be made by using a plastic trash can lid. Attach a rope to the lid to be able to pull the sledge. Alternatively, use a large plastic tray or purchase a sledge from a sports store.
To make a hanging drop slide, you will need: -a depression slide -a square coverslip -some petrolatum -the liquid suspension of what you wish to view Place a small spot of petrolatum on each of the 4 corners of the coverslip. Place a drop of your suspension in the center of the coverslip. Invert a depression slide over the drop, allowing the petrolatum to attach the coverslip to the depression slide. Quickly (but carefully) invert the slide so that the coverslip is oriented "up", and the drop is hanging into the slide depression.
Lee Filters attach to an SLR camera by sliding into the grooves on the camera. The grooves will hold the Lee filter in place until you slide it in the opposite direction.
Raise the lift links fully, turn front wheels fully left, slide deck in from the right (gearbox is on right), lower lift links with height set to 0, attach links on sides and U-shaped link a front and slide collar on driveshaft coupling to attach it to PTO shaft. Lift and set to desired cutting height and lower.