After you have completed work on the cooling system and you begin to replace the coolant, open the bleeder a couple turns. As you pour coolant into the reservoir air trapped will escape out the bleeder. As soon as you see coolant come out of the bleeder close the bleeder valve and continue to add coolant to the reservoir until you have reached the full mark. Replace cap on reservoir. Allow vehicle to run through a drive cycle and cool down. Top off reservoir to full mark if necessary.
The bleed valve on a 2000 Chrysler Sebring is located on the top of each brake caliper. It allows air to be purged from the system to ensure maximum braking power.
No.No.
It is on the throttle body.
No.No.
Nothing used with that name.
It is inside the transmission, on the valve body.
Middle of the valve covers.
You can not. There is an anti siphon valve in the filler neck.
They are accessed through the top of the valve cover.
They go into the cylinders through the middle of the valve cover.
The Chrysler Sebring knock sensor is located in the engine valve or cylinder located at the back of the motor. This part is in this position next to the engine valve so the sensor can feel the vibration of the engine.
EGI.. do you mean EGR?