answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you breakdown a gear stick on a Massey Ferguson 135?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where do you put hydrolic fluid in 399 Massey Ferguson?

Beside the gear shift levers


Where do you put hydraulic fluid in a Massey Ferguson 175?

On the left side of the gear shifters


Where do you put hydraulic fluid in a Massey Ferguson 290?

To the left of the gear shift lever, large plug on top of transmission. Fill here,


What type oil is used in the Massey Ferguson 65 hydraulic system?

sae 90 gear oil. it is 100% mineral oil. napa, car quest, call your local massey dealer they have it. you will pay a little more but they have all the answers.


There is a dip stick next to the seat on the right hand side of the seat on a Massey Ferguson 165 the level shows that it is low and I am unable to find an oil filler hole do you know where it is?

You're probably looking at the transmision/hydraulic oil level. The filler hole is a hex-head bolt just below (towards the seat) from the left-hand gear stick.


How do you get your Massey Ferguson to shift out of reverse it is stuck in reverse?

If the trans is locked in one gear, and the stick refuses to move, it has very likely jumped out of the shift selector rods. You will likely have to remove the shift stick cross pin, to pull the stick out, and manually with a long flat screw driver, shift all rods to the neutral position. There are cut aways in the rods. The neutral position should be when they are all in the same general location so the stick can move between them. Test this by bumping the starter, before replacing the stick.


Where do you put hydraulic fluid in a Massey Ferguson 285?

to the left of the gear lever is a cap with a 1 1/16 bolt head on it. remove that cap and fill there. To check the level the is a small dipstick under the lift on the frame.


Where do you put hydraulic fluid in a Massey Ferguson 165?

There is a cap right next to the gear shifters. It's about 1-3/4" dia or so with a hex head on top. The hydraulics share the same fluid as the transmission.


Why does your gear stick sometimes stick when changing gear?

linkage is sticking


How do you down shift gears in a stick shift?

The gear stick has a diagram of where to move the stick to engage a certain gear. For example, if Gear 1 is in the top left corner, you must move the stick to the fair left, then forwards to engage first gear. Oh, and you have to push down the clutch each time you change gear.


How does a gear stick work?

nathan


Why does reverse gear not work in barina?

You need to lift the collar on the gear stick to engage reverse gear