Early models used a 2 pin plug under the seat - unplug it, put a jumper wire in the plug and tape it up - done.
Later models used a 3 or 4 pin tamper proof plug - without pictures it is a little harder to explain this, but it is simple once you understand the instructions.
1) move the seat all the way forward
2) Lift the seat
3) Unplug the safety swtich
4) Look at the plug side of the plug (not the wire side)
5) Look closely at the plug and you will see the wire connector (where the plug prongs go in) and running sideways you will see 3 or 4 small tabs that you can push away from the connectors (make sure you have identified the right thing).
6) Gently pull that metal tab out of the plug
7) Leave it UNPLUGGED to bypass the seat safety - and plug it in to turn it back on.
WARNING: This seat safety switch is in place to make sure you do not get ran over by your own lawnmower from doing something stupid, so IF YOU ARE STUPID please do NOT bypass this switch.
To bypass the cars neutral safety switch, you need to find the two wires to the safety switch and connect them together. It can also be done by putting the car in neutral.
How do u bypass the neutral safety switch in a 2002 chevy silverado 1500
Not a good idea. It is called a safety switch for a reason.
Neutral switch
can you by pass a safety neutral switch on a 2001 dodge neon
You CAN"T.
yes
you can't
Yes you could but it has a neutral safety switch for a reason.
Yes, you can. However I would not recommend it.
The clutch safety switch is located at the clutch pedal arm same as the brake light switch but slightly bigger.....To bypass the switch, just disconnect one wire or put a jumper wire accross the 2 wires to the switch depending on how the circuit was designed.......Since it is called a safety switch I won't recommend altering it....
It doesn't have one, it has a switch on the clutch pedal. It also has an interlock switch on the dash, turn the ignition switch on and press the interlock switch and it will bypass the clutch switch.