I order to do this all the wire need to be replace with three wire.
Green wire must be grounded for safety. The two white wires are phase and neutral. You can discover which one is the hot wire by using a mulltimeter. But there is no needing to discover it. About the green wire only an electrician can install it properly. It can be joined to the neutral wire, but it is not advisable for any electrical device. The correct procedure is to connect the ground wire on the recommended manner. Normally lamps do not need to be grounded.
This is the most common type of home electrical wire that is installed for general purpose electrical circuits, also known as Type NM or Non-Metallic sheathed cable made up of at least one pair of insulated wire conductors and one bare wire used for the ground conductor. This kind of wire have 3 sizes, PDX 14/2, PDX 12/2, and PDX 10/2. The ground conductor is bonded throughout the home to maintain a contiguous grounded system which originates back at the Main Service Panel. Most electrician know this kind of wire as Loomex, Romex, and PDX.
with a standard 1 pole light switch (one switch operating the light) it is black wire to black wire and white to white (non grounded)
The resistance can be changed in following two ways: 1.By change the length of the wire. 2.By changing the area of cross section of the wire.
2 pole, 3 wire.
2 plus 2
An electrical tester is tool used to check if a wire is producing an electrical current. Usually you will just hold it to the end of a wire, if an electrical current is being "induced" a light will glow on the tester, this is a live wire.
.0011 1/2 of an inch
A conductor used for grounding of the main service should be a single wire. The code book has a table that states the size of ground wire for different service panel amperages.
Change the outlet to a grounded one. Get an adapter that goes from 3 prong to 2. Break the ground prong off. Any one of these will work.
Well Grounded's population is 2.
With the running lights turned the wire that has 12Volts will go 2 the bulb wire that is not as bright as the other-one filiment willb dim & the other will b bright.DIM is your running lights-the other wire is your turn signals..& make sure the groung wire is grounded 2 a clean mounting bolt .