answersLogoWhite

0


Best Answer

Pry at the base (from the rear) of the map light cover. There are 2 slots in back that when pryed gently with a screwdriver; will allow you to pull the whole cover forward into your hands. When you are done replacing blubs just pop it back into place.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change a map light bulb in a 1997 Toyota 4Runner?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change the fuel filter on a 1997 Toyota 4Runner?

every 130,000 miles :)


How do you replace the tailgate's window motor on a Toyota 4Runner 1997?

how do remove the tailgate's window motor on a toyota 4runner 1997 ?


How do you change the front brakes on a 1997 Toyota 4Runner?

Take it to a brake shop. If you have to ask you aren't qualified to do it.


What do you do if the check engine light comes on in a 1997 Toyota 4Runner and stays on?

go to auto zone and have them check it for you. its free


Does the 1997 Toyota 4runner have a cabin air filter?

No.


How many oxygen sensors does a 1997 Toyota 4runner have?

none


Where is the obd2 port on 1997 4runner?

The 1997 Toyota 4Runner OBD 2 port is under driver side dash next to center console


How do you open gas tank door for toyota 4 runner?

How to open gas cap toyota 4runner 1997


Where is the airbag control module located in a 1997 Toyota 4Runner?

Below the center console.


How much horsepower does a 1997 Toyota 4Runner have?

The 1997 Toyota 4Runner with the 6-cylinder, 3.4 liter V6 produces 150 horsepower at 4,800 rpm. This vehicle gets 15 miles to the gallon in the city and 19 mph on the highway.


Where is the starter located on a 1997 Toyota 4Runner?

The 1997 Toyota starter can be found on the right hand side of the engine. The starter will be near the back of the engine, at the bottom.


How do you disarm a 1997 Toyota 4Runner factory Alarm?

To disarm a 1997 Toyota 4Runner factory alarm, place the key in the ignition. Turn the key about halfway ensuring the car does not start. Leave the key in that position for 10 to 15 minutes and start the car.