Serpentine Belts
Power Steering
Jeep Wrangler

How do you change a power steering belt on a 1989 jeep wrangler?

212223

Top Answer
User Avatar
Wiki User
2007-12-29 05:31:45
2007-12-29 05:31:45

remove old belt install new belt you're welcome

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

They are both YJ's so it should be a good fit.

User Avatar

How to change the power steering pump depends on which engine your car has.

User Avatar

The whole thing, ends and all needs to be changed, it is a hydraulic line and will blow off under pressure if you don't

User Avatar

A 1989 Jeep Wrangler needs 6 quarts of oil for an oil change.

User Avatar

The 1989 BMW 750 power steering reservoir is located on the back side of the engine. The power steering reservoir will be between the engine and the firewall.

User Avatar

Secure the power steering pump with the retaining bolts. Attach the power steering hose to the power steering pump. Put the belt on to the power steering pump. Fill the power steering system with fluid.

User Avatar

You have to remove the power steering belt and the AC belt to remove the alternator belt.

User Avatar

you will need a power steering pulley puller other than that its gravy

User Avatar

I am guessing it does. I own a 1989 Shadow and it has power steering. 99.9% of vehicles made after 1985 have power steering...however some vehicles had it before that. My 76 Ford Truck has it...

User Avatar

The power steering pump is located on the front of the engine. The uppermost pump connected to the serpentine belt.

User Avatar

Use DEXTRON II. Remove the power steering fluid reservoir cap, and fill the power steering reservoir until the fluid reaches the ''full'' line.

User Avatar

Follow the lower rad hose,to the themostat housing. If you have power steering you need to drop the power steering pump down.

User Avatar

I believe that any kind of power steering fluid will work. You can actually use any type of hydraulic fluid (i.e. brake, power steering, or transmission). It is usually best to use only power steering fluid if you can get it.

User Avatar

Looking at the engine on the left side under the A/C compressor . That is the power steering pump. Uses ATF.

User Avatar

How do you replace the clutch slave cylinder on a 1989 jeep wrangler

User Avatar

The fluid reservoir should be built onto the power steering pump. There will be a cap on top to fill through.

User Avatar

There is a power steering reservoir under the hood of the car. Remove its cap, and the dipstick is attached, this is where a person can check the fluid level.

User Avatar

No. A Jeep Wrangler does not have an inertia switch.

User Avatar

No. A 2009 Wrangler and a 1989 Wrangler have a different bolt pattern.

User Avatar

you could use regular transmission fluid.

User Avatar

The fluid could be leaking from the pump, hoses, or steering rack. Wash the steering system, then you can see where the leak is coming from.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.