Disconnect the negative terminal on the battery; disconnect the sensor connection; the sensor is located in the exhaust; drowned the threads in release compound; don't even try to remove an O2 sensor without first doing this, you will stip the threads or break of the sensor; let soak for about 5 mins, then unscrew; might be necessary to heat also with a torch, clean threads in exhaust and put and antiseize compound that is sensor safe and reinstall to appropriate torque, and reconnect sensor and battery.
Back of the engine next to the coil packs.
On my 99 sunfire it is directly to the back/side of the alternator; very easy to spot
you can as long as it is withing certain years 1996-1999 cavalier engine will work in a 96-99 sunfire and a 99-02 cav engine will fit a 99-02 sunfire
Answer There are two o2 sensors, one on the intake manifold and the other on the catalytic converter.where is the oxygen sensor located on 99 Honda accord
The bcm for a 99 Sunfire should be under the dash. It is on the drivers side near the kick panel.
look on the exhaust pipe before and after the catalytic converter
There is one Oxygen sensor on the 99 Acura TL model. Replacing it or repairing the O2 sensor can help the longevity and efficiency of your car and is a fairly simple procedure.
The upstream O2 sensor is mounted in the ehxaust manifold The downstream O2 sensor is mounted in the exhaust pipe after the catalytic converter
actually it's called a temperature senson and on my 99 sunfire 2.2 it's right behind the alternator with a 2 wire connector cost around 15.00 if you unplug it with the motor running the fan will come on actually it's called a temperature sensor and on my 99 sunfire 2.2 it's right behind the alternator with a 2 wire connector cost around 15.00 if you unplug it with the motor running the fan will come on
one of three places manifold y pipe or near the cadiletic converter
Where is the knock sensor for a 99 pathfinder
Bank 1 means where number 1 cylinder is. sensor 1 is the O2 sensor before the cat. converter, not after the cat.
* Remove the front bumper fascia * Unplug the horn electrical connector and remove the bracket bolt
my 99 e250 with 5.4 gas engine has 2 upstream sensors and 1 down stream sensor.
It's in the exhaust manifold. Be aware that some 99 camry's have air-fuel sensor, others have oxygen sensor instead at the same place.
oxygen sensors are located just forward of your engine. In front of the engine is the catalytic converter. At the top at the bottom are your oxygen sensors.
You can't. the computer will not function properly with out working oxygen sensors.
there is a short some where check the wires as well as the oxygen sensor.
On the 3.0 L and 4.0 L there are 2 oxygen sensors at the front and 1 oxygen sensor (which monitors your catalytic convertor efficiency) at the back after the exhaust gasses have passed through the convertor. On the four cylinder engine - 1 oxygen sensor at the front - 1 oxygen sensor at the back (downstream of catalytic convertor - monitors catalytic convertor efficiency) Helpfull
Which oxygen sensor? There are two of them. They each have 4 wires and each wire has two colors. There were two models of the f250 also, need to know engine size. Sorry.
Why the hi beam and day light are not working but the low beam are working good on sunfire 99?
change MAP sensor
No not always,But it will correct problem 99% of the time. Brett
in the exaust manifold by the donut rong before it goes into cad conv pipe