0
How do you change cam shaft sensor in 1997 Dodge Intrepid 3.3?
Wiki User
∙ 14y ago
You get the cam sensor from auto parts store and buy a can of PB blaster - you take out the bolt on the bracket and disconnect wiring harness. Then you spray some PB blaster on the sensor and what about 10 minutes. Start gently wiggling the sensor, slowly. There is an o-ring that makes it snap down in and if you pull too hard it will break apart (not good) - then you put the new one down in and put the bolt back in and reconnect the wires.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the camshaft position sensor located on a 1999 Dodge Intrepid 2.7 and what do you have to do to change it correctly?
It is on the left front of engine. Points at the left front cam shaft. UNplug the wire , unscrew bolt, and pull sensor out.
Will not crank no fire codes OK coil OK 96 Dodge Intrepid 3.5 what to mlook for?
try crank position sensor and cam shaft sensor
How do you replace the cam shaft sensor in a 1998 Dodge Intrepid?
buy a new one or junkyard drop it in and start it up its got a paper spacer so make sure its there
You own a 1997 Dodge Intrepid that will randomly shut down ie the engine will either not start or it will shut off while driving it restarts after 1-25 minutes and runs fine again?
try the cam shaft sensor
How do you replace a camshaft sensor in a 2002 3.3L dodge grand caravan?
how do you replace a cam shaft sensor in a 2002 3.3L dodge grand caravan
The how to change CV half-shaft on a 1997 dodge stratus ES?
how to chance a CV shaft on a 1997 dodge stratus
Can you Show picture of cam shaft sensors for Dodge 2002 Intrepid?
ANSWER : Go to auto parts,buy a Manual Book for your dodge 2002 intrepid.Check Engine electrical systems and Emissions and engine control systems chapter.They have many ilustrattions pics of must sensor and electrical system possittion.
Where is the crank shaft sensor on the 2000 dodge intreped?
It's on the passenger side of the bellhousing.
How can you tell if the crank shaft pulley is broke in a 2000 Dodge Intrepid 2.7 liter 6v engine?
Take It Off Amd Inspect It.
Does a 1995 dodge Dakota with 2.5 L have a crank shaft sensor?
No, just the distributor pick up plate (cam sensor)
Where is the cam shaft sensor on a dodge ram 1998?
it is the "pick up" plate inside the distributor.
Where is the crank shaft sensor on a 2000 Dodge Cummins Diesel?
It is in the side of the block behind the starter.
