0
there is a bolt off to the right off the sensor take it out and it should just pull right out.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
If the crank position sensor 1998 Dodge Dakota magnun v6 is not work what would happen?
If the crank sensor is not working, the engine will not run.
95 dodge stratus v6 2.5 ltr where is the crank position sensor located?
on the 1998 the camshaft sensor is in the distributor ,you have to change it....you have to change the whole distributor..the sensor is integrated. the crankshaft sensor is located on the block under the cruise control actuator
Will a speed sensor in a 1998 dodge neon stop the car from starting?
Crank and cam sensors, yes. Vehicle speed sensor, no.
What will cause no power to the coil pack on a 1998 dodge mini van 3.3?
crank shaft posetion sensor
Where is the Location of crank sensor on 1998 Dodge Dually 3500?
12 valve engine: front above the crank pulley 24 valve engine: behind the starter.
1998 dodge stratus where is crank sensor located?
On the 4 cylinders it is in the rear of the block. On the 6 cylinder it is in the top of the bell housing.
Where is the crank position sensor on a 1998 Dodge Dakota 5.2L?
Top of the bell housing, pass side, behind the cylinder head.
Where is the crank sensor located on 1998 Bravada?
the crank sensor is located just behind the crank shaft pully of the engine.
Can you change the crankshaft sensor without having to change the whole distributor on a 1998 Chrysler cirrus?
The crank sensor is not in the distributor, it is in the top of the bell housing. The cam position sensor is in the distributor and is not available separately
Is the crank sensor the same as the cam sensor on a 1998 ford escort wagon?
No
Where is the crank sensor located on a 1998 dodge 1500 pickup?
It`s on the flywheel or it`s between the motor and trans and it`s on the passinger side I hope this helps
What does a crank shaft sensor do on a 1998 Honda accord?
A crank shaft position sensor on a 1998 Honda Accord reads whether or not a the engine is spinning correctly. If there is a discrepancy on how the crankshaft is spinning the sensor will relay it to the ECU.
