If you cant get to it from the front, you will probably have to look from the back and see where the wires connect to the back. Then you should be able to unscrew the fixture from the plastic and replace the bulb.
In the fuse panel on the drivers end of the dash , the panel cover is visible with the drivers door open , and it is fuse # 8 - 10 amp - for right headlamp and fog lamp system
2 sliding bars hold headlight in remove and pull headlamp forward and out
Send me photos of the front and back of the headlamp to the email address on my bio page, and I'm pretty sure we can figure it out.
you need to remove the front fascia to remove the headlamp to change the bulb
The front bumper facia needs to be removed to access headlamp assemblies.
Standing in front of the bad headlamp, with the hood open, notice the two black tabs sticking up behind the headlamp assembly. These are locks that hold the headlamp assembly in place. Remove the locks by wiggling and pulling straight up. Now the headlamp assembly will drop out the front far enough to twist out the bulb socket to change the bulb. Reverse for installation.
In the 2009 the horn (pathetic thing that it is) is under the drivers side headlamp. The headlamp comes out with two screws on the top and you might need to remove the plastic buttons to allow the front grill to flex a little to get the headlamp out. I have not located the SPST relay yet, if there is one.
same as the other side 3 screw bolts then pull
The headlamp bulbs on a 1996 Acura TL are installed from the engine bay. Find the housing located in the front of the vehicle. Disconnect the bulbs and replace them with new units.
behind the drivers front wheel.
You have to remove the front bumper to change the head lamp , i did it one time on my Mazda 6 2003 . Regards Abdullah al brahim from K.S.A
You will need to remove the front grill and the whole front bumper to access the headlamp housing. It's quite easy once you've done it.