1995 2.4l galant has two oxygen sensors. one before and one after catalytic converter. Get some WD-40 and spray were they are screwed into exhaust system ,then disconnect oxygen sensors and use good size wrench to loosen. When you put back in or purchaes new ones make sure you coat threads with antiseize compound before installing,unless you never ever want to get them ou again.OH the second sensor is very easy to disconnect if you take out front drivers seat., 4 bolts and its out.
On the downpipe before the catalytic converter.
Both before and after.
It should be equipped with both.
where is bank1 sensor2 on the 1999 Mitsubishi montery sport 3.5
It's on the exhaust manifold right under your hood, at least it is in my 2000 Galant 2.4 L.
Where is the crank position sensor 0n a 2001 mitsubishi Galant
P0135 on Mitsubishi galant 2003 Definition: HO2S 11 Heater condition (Heated Oxygen Sensor Bank 1 Sensor 1) Explanation: The powertrain control module monitors the oxygen sensor heater. The computer has recognized a failure in this ciricuit. Probable Causes 1. -Oxygen sensor defective 2. -Poor connection at oxygen sensor 3. -Check circuit-fuse
Its in the distributor
Speed sensor
the speed sensor for 2004 Mitsubishi Galant is located on the front case of the transmission output shaft and speed sensor. It is approximately under the hood to the left of the engine.
There are two oxygen sensor for Mitsubishi Outlander. Front Oxygen Sensor and Rear Oxygen Sensor
Mitsubishi Galant, 2002, 4-cyl, O2 sensor, bank 1 sensor 1 (upstream)... PART NUMBER: MR506364