Spark Plugs and Wires
Jeep Liberty Sport

How do you change spark plugs in a Jeep Liberty 6 cylinder?


Top Answer
User Avatar
Wiki User
2015-07-15 21:04:18
2015-07-15 21:04:18

1) Remove the air filter manifold. It will clip on the air filter on one side, and there will be a ring fastener on the other.

2) For the 3 plugs on the driver side, use a 10 mm nut driver to remove the locking nut of the spark plug terminal.

3) Disconnect the harness from the plug terminal.

4) Pull out the terminal.

5) Use a socket wrench to remove the plug.

6) For the 3 plugs on the passenger side, you will need to remove the Radiator Coolant resevoir. This is fastened with 2 10mm nuts. Once removed follow steps 2 to 5 for each plug.

Note that on the Radiator it will state what the gap should be for the spark plug.


Related Questions

User Avatar

It is moderately easy to change the spark plugs on a Liberty, although it is rather tricky because of the gap between the spark plugs.

User Avatar

how to change spark plugs on a 2004 Hyundai sonata 6 cylinder

User Avatar

There would be six spark plugs for a six cylinder engine. One for each cylinder. Unless it is a diesel, then there are no spark plugs.

User Avatar

On the gas engines, one per cylinder. Zero on the diesel.

User Avatar

The gas engines use one per cylinder.

Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.