For 4WD - 3.2L V6
1 REMOVAL
- Disconnect the radiator hoses from the engine block.
- Remove the upper fan shroud.
- Remove the fan assembly from the fan idler shaft.
- Slack the "V" belt tensioner hold bolt (front of the pulley)
- Slack the "V" belt tensioner pulley bolt (top of the tensioner & pay attention to the
jam nuts).
- Remove the "V" belt.
- Remove the "V" belt tensioner
- Slack the A/C grooved belt tensioner hold bolt (front of the pulley)
- Slack the A/C grooved belt tensioner pulley bolt (top of the tensioner & pay
attention to the jam nuts).
- Remove the A/C belt.
- Slack the alternator swivel point bolt on alternator top mounting bracket.
- Slack alternator tensioner hold bolt (on the lower bracket and clamping the
alternator lock block to the bracket).
- Slack the alternator grooved belt tensioner (on lower alternator bracket).
- Pry alternator toward engine.
- Remove the alternator belt, which will dislocate the fan pulley, so remove the fan
pulley too.
2 ASSEMBLY of the new alternator belt
- Install the new alternator belt and also the fan pulley on the fan idler shaft
flange. Make sure the fan shaft studs are located in the 12 - 3 - 6 - 9 configuration
and install a temp nut with dummy washers to hold the fan pulley in place.
- Pry the alternator away from the engine.
- Tighten the alternator tensioner hold bolt system in reverse order as you
disassembled it.
- Tighten the alternator grooved belt tensioner so that the belt still has about 5mm
movement when you push it down in the middle between the two most extreme
pulleys.
- From here work in reverse order from the disassembly stage.
- When getting to the point the fan has to be assembled, remove the nut and the
dummy washers, the pulley will stay in place.
- Continue in reverse order.
- When everything is tight and secure, hoses included, fill up with 50/50 antifreeze
and check for leaks.
where is the pcv valve located on a 1995 Isuzu rodeo v6 3.2l
The alternator retaining bolt size is 9/16. The alternator bolts will be three inches long. The alternator tensioner bolt is 9/16 by one inch.
Hello... what is the original size of the muffler that came with a 1995 Isuzu Rodeo lengh etc...
How do you adjust the valves on a 1995 isuzu Rodeo 3.2
www.tirerack.com
On the left
it takes 3.2L
Hi, How Do You Replace a Starter on a 1995 Isuzu Rodeo, V6, 3.2 liter engine? Does anyone know where the starter is? Help. How Do You Replace a Starter on a 1995 Isuzu Rodeo, automatic, 4wd, V6, 3.2 liter engine? Does anyone know where the starter is? Thanks alot.
when all three of those lights turn on that means that your alternator is bad. i just went threw this same problem with my rodeo
it will fit but you will have to get new hoses for the correct sizes
The diagnostic port on a 1995 Isuzu Rodeo drive is located on the lower kick panel on the driver's side. It is just below the left spark plug.
It's 4500lbs