Want this question answered?
How do you change the choke cable on a 2000 Honda Rancher?
how to change choke cable
The procedure is somewhat different on different kinds of bikes but basically you have to disengage the cable at the choke lever on the handlebars or closer to the engine, depending on the type of bike. Then, you have to unfasten the part that is connected to the carburetor or carburetors. The cable may need to be adjusted to fit properly. Look for the specific model and year of bike or vehicle you have and how to change the choke cable.
(1) Loosen the choke cable at the cable control bracket but do not remove it. (2) Pull cable knob or lever all the way to closed position. (3) Manually close the choke baffle all the way. (4) Tighten the choke cable at the cable control bracket. (5) Ensure choke opens and closes properly by pushing and/or pulling the cable knob or lever.
how do you replace a choke cable on a 2001 Honda 450 foreman
You need to adjust the Vernier knob on the choke. It is located behind the choke knob. It is a knurled ring that you tighten up to tighten the shaft friction on the choke cable
How do you change the choke cable on a 2000 Honda Rancher?
Loosen the cable at the carb and hold the choke valve wide open. Then tighten the cable. Check to make sure it closes all the way when you pull the choke lever.
The top speed of a FJ60 is roughly 75 miles per hour, although at this speed one is traveling at a very dangerous rate of speed. A much safer speed to travel with the FJ60 is about 60 miles per hour.
how do you hook up a manuel choke on a small block chevy
The choke control should have a cable attached to it that attaches to the choke on the carburetor at the other end. If you have no movement at the carburetor when you move the choke lever, look for the cable to be disconnected at either the choke lever or the carburetor.
Change the barrel unless it has removeable choke tubes. In that case, change the tube.