0
How do you change the harmonic balancer in a 1994 buick lesabre?
Wiki User
∙ 12y ago
I tried to change the harmonic balancer of my biuck lesabre 1994, but i can't remove the old one, the bold in the center is very , very tight and i don't know the type of screw, right or left turn.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you change harmonic balancer on 1991 buick lesabre?
The flywheel has to be held in place by a holding tool, Remove the mounting bolt, then use a balancer remover to pull the harmonic balancer.
1995 buick lesabre crankshaft senseor location?
it is behind the harmonic balancer.
Where do you find the crank position sensor for a 1997 buick lesabre?
its behind the harmonic balancer attached by two bolts but you must first take off the balancer to get to it
1997 BUick LeSabre Custom location of crankshaft sensor?
the crankshaft sensor is located behind the harmonic balancer on the ft timing cover
Where is the Crankshaft sensor on a 2000 lesabre?
The 2000 Buick Regal 3.8L Crankshaft Position Sensor is located behind the harmonic balancer pulley.
The main flywheel off the crankshaft that runs the belts pulleys on your 1986 Buick Lesabre is vibrating causing a rattling clanking sound how do you resolve this?
sounds like the rubber damper is worn on the harmonic balancer. if this is the case you will have to replace the harmonic balancer.
Why would a 92 Buick LeSabre not run turn over after Serpentine belt shreds?
probably damaged the crank sensor, or the tangs on the harmonic balancer
How do you pull a Harmonic Balancer on a 1992 Buick Riviera.?
You need a harmonic balancer puller, and a 1/2 in drive inpact wrench.
Where is the crankshaft sensor on a 1998 buick lesabre?
The Crank sensor in my 91 LeSarre Limited is behind the Harmonic balancer pulley....there are fins on the back of the pulley that line up with the sensor.
Where is crankshaft position sensor on 97 buick lesabre 3.8?
The Crankshaft Position Sensor is behind the crankshaft pulley (harmonic balancer). You will need a ½-inch drive breaker bar and appropriate socket.
How do you get the retaining bolt off a 96 buick lesabre harmonic balancer?
I usually use my impact wrench but if you don't have one you could put a socket and wratchet on it. Then tap it with a hammer to get it started maybe.
How do you remove the crankshaft pulley on a 2003 buick lesabre 3.8 engine?
Its refered to as a harmonic balancer, and you have to have a special tool to remove it called (surprisingly) a harmonic balancer removal tool. The installation tool is a good heavy hammer and a block of wood. If you dont have access to this special puller, you can (and likely will) damage the harmonic balancer, so it would be best in that instance to take it to your local mechanic and ask him to take pull it off for you.
