Want this question answered?
n ignition switch on a 1991 Chevrolet astro vanAnswern ignition switch on a 1991 Chevrolet astro van
Remove the retaining ring at the top of your 1991 Acura Legend ignition switch. The ignition switch cylinder will slide out. Remove the wiring harness from the end of the ignition cylinder. Reverse the process to install your new ignition switch cylinder.
Ok so you have to go where the ignition switch is at on the 1991 cougar. Next, You have to take the old one out. Last, you have to put the new one in.
I don't know how to change the ignition switch but I have some advice. Don't screw with the ignition switch, buy the whole steering column. It will be cheaper and easier to change.
Remove steering wheel and signal switch
The 1991 Mercury Sable ignition switch is held in place with a retaining ring. Loosen the retaining ring. Pull the ignition switch out. Remove the wiring harness from the rear of the ignition switch. Reverse the process to install the new ignition switch.
How to remove ignition switch on a 91 Mazda Navajo
Need to specify the model. GMC made trucks ranging from the Class 1 S-15 all the way up to Class 8 variations of the Top Kick.
No.
your local library may have a free shop manual to peek at.. good luck Dave
remove the plastic surround. put the key in the ignition and turn to accessories . look at the end of the ignition switch cylinder for a small pin that will depress. when depressed the ignition will slide out. the new one goes in the same way . no tools needed except for the plastics part.
The entire ignition switch assembly will unholy from the steering column. The key is required to remove the cylinder from the switch.