Saturn (car)

How do you change the map sensor on a 1993 Saturn SC1?

181920

Top Answer
User Avatar
Wiki User
2009-03-06 02:14:32
2009-03-06 02:14:32

The MAP sensor is a black rectangle bolted to the back of the intake manifold on the passenger side of the engine. Removed the two bolts, disconnect the vacuum tube, and remove the electrical connector. Be careful as the vacuum tube can be brittle and the clip on the electrical connector is easy to snap. Installation is the reverse of removal.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

How to remove the wiper motor on a 2002 Saturn sc1

User Avatar

It does not have a belt, it has a chain.

User Avatar

i have a 1993 saturn sc1.the relays in the sunroof keep the sunroof from working.anyway to fix it

User Avatar

http://youtube.com/watch?v=JC0U53w_Htk

User Avatar

IT IS MOST LIKELY THE TRANSMISSION FLUID TEMPATURE SENSOR

User Avatar

its located next to a few nuts and blots

User Avatar

The 1991 Saturn throttle position sensor can be found on the firewall in the engine compartment. The throttle position sensor will be on the drivers side of the firewall.

User Avatar

Could be throttle plate stuck open Try to free it with screwdriver with engine off

User Avatar

your horsepower is about 85 horses not sure on torue

User Avatar

The wiring diagram for the wiper motor on a 1993 Saturn sc1 can be found in the Saturn service manual. The manual might be available at the local library, or can be bought through most any auto parts.

User Avatar

For the Satur S-Series there is no camshaft position sensor. They never installed it in that model

User Avatar

In the cylinder head,check richpin06a on YouTube for further information.

User Avatar

Yes. The sc1 is a coupe.

User Avatar

The minimum price for a 1995 Saturn SC1 trailing arm is $50.

User Avatar

http://youtube.com/watch?v=D3o4IuScZZI

User Avatar

my 1995 Saturn sl2 has a factory alarm, my daughters 1997 sc1 also has one

User Avatar

1999 saturn sc1 , need radio code. 4 digit from radio is 1407

User Avatar

The easiest way to access the pulley is to remove the front right wheel and fender liner. The pulley will be right behind the liner.

User Avatar

I believe it is on the block where your engine coolant runs into the block from the radiator. There should be two wires that run to a plastic-like sensor.

User Avatar

It should take you less than a half an hour to replace the TPS sensor.

User Avatar

remove the torx screws that hold in place, remove the bulbs from sockets

User Avatar

It's behind the starter. I found this on a search look here . http://thecommi.angelfire.com/index.html


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.