hi you unscrew the whole of the light 2/3 with x screwdriver from the outside.
How do you open the tail light onTake it to a garage you tight git
under the carpet in the trunk
Yes. Although you may have to change mouonting strike plates and/or pig tail for defroster. This and more questions answered on:www.miata.net/garage/hardtop
The tail light covers (the painted bezels) are only held on by 3m Automotive, double-sided tape.
The tail light bulb is probably okay, it's the front signal light that is burned out, this would cause the rear light to blink rapid.
Hey Jesse==You have to take the tail light completely off. The bulbs go in from the back Good Luck Joe
How do you change the tail light on a 2001 toyota sequoia
how to change tail light bulb on Toyota sequoia
from inside the trunk just take the plastic pins out that hold the carpet directly behind the tail light and twist the light socket out and change the bulb
Remove the rear tail light assembly by pulling the carpet back and unscrewing three thumb screws. Pull out the tail light assembly and the bulb sockets will be visible. twist out the socket to access the bulb. Install is reverse.
on the tail light problem - unbolt the tail light from inside th truck -the hold tail light assemble will come out - it is recommended to change all the blubs your all ready there
You can not, you will have to replace the entire tail light.