0
iF YOU LOOK AT THE MOTOR YOU WILL SEE A HOSE THAT CONNECTS TO THE RADIATOR. THERE ARE TWO BOILTS REMOVE THEM AND YOU WILL SEE THE THERMOSTAT. JUST TAKE IT OUT AND PUT THE NEW ONE IN. MAKE SURE YOU CHANGE THE GASKET TOO.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
When was Dodge Intrepid created?
Dodge Intrepid was created in 1993.
Where is the crank sensor on a 1993 Dodge Intrepid?
where is the crankshaft sensor located on a 1993 dodge intrepid
What runs the temperature gauge in a 1993 Dodge Intrepid Gauge not working but fan is and check engine light is on.?
try replacing the thermostat
How do you replace a push rod in a 3.3l v6 engine on a 1993 Dodge Intrepid?
O,YEA AND I FORGOT TO MENTION IT IS A 1993 DODGE INTREPID...
Your 1993 Dodge Intrepid keeps over heating you have already changed the thermostat thermostat housing upper radiator hose radiator and pressure cap what is left to change?
You could have a bad water pump causing no coolant flow, inoperable radiator fans, a coolant leak,............
Where is the speed sensor on a 1993 Dodge Intrepid?
in the trans
What is fuel capacity of 1993 Dodge Intrepid?
About 18 gallons
Where is the reset switch on a 1993 Dodge Intrepid?
Dodge does not use inertia/reset switches.
What is the tire size for a 1993 Dodge Intrepid?
The 1993 Dodge Intrepid had two OEM tire sizes. The factory fitments for this vehicle were the P205/70/15 and P225/60/16 sizes.
What is the weight of a Dodge Intrepid?
The curb weight of the Dodge Intrepid in 3,318 pounds of 1,505 kilograms. It was produced for model years 1993 until 1997.
If you changed the battery in a 1993 Dodge Intrepid 3.3 automatic and now it will not change gears what could be the problem?
check your alternator it might be bad.
Can you swap a 2.7 2000 dodge intrepid engine for a 1993 3.5?
NoNo
