answersLogoWhite

0


Best Answer

Should be located in a removable housing at the engine end of the upper radiator hose Drain about 1 gallon of coolant from the radiator

Remove this housing

Note how thermostat is installed

Clean both surfaces

Install new thermostat and gasket

Reinstall housing

Re-fill coolant slowly to prevent an airlock

Start engine and look for leaks

Run engine to normal operating temperature with heater on

Re-check coolant level

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change the thermostat on a 1996 Chrysler town and country?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the thermostat located on a 1996 Chrysler Town and Country van?

It is under the housing where the upper radiator hose attaches to the block.


How do you reset a kill switch on a 1996 Chrysler Town and Country?

A 1996 Chrysler Town and Country does not have a kill switch.


How do you activate valet mode on 1996 Chrysler Town and Country?

There is no valet mode on a 1996 Chrysler Town and Country.


How do you bleed the injectors on a 1996 Chrysler Town and Country?

The fuel injectors are self bleeding on a 1996 Chrysler Town and Country.


How much does the thermostat in a 1996 Chrysler cirrus cost?

The actual parts cost about $4.00 to $8.00 but if you have a mechanic change it for you expect to pay around $70.00 in labor.


How do you reset your alarm system on a 1996 Chrysler town and country lxi?

how to reset the antitheft alarm system in a 1996 Chrysler town&country lxi


How do you change a thermostat in a 1996 jimmy?

kick it.


Where is oxygen sensor located on a 1996 Chrysler Town and Country?

A 1996 Chrysler Town and Country has two oxygen sensors. They are screwed into the exhaust on the rear of the engine.


Where are the oxygen sensors located in a 1996 Chrysler Town and Country?

The oxygen sensors on a 1996 Chrysler Town and Country are screwed into the exhaust system behind the engine.


Does a 1996 Chrysler town and country have a kill switch?

No.


Does a 1996 Chrysler town and country have inertia switch?

No, Chrysler does not use inertia switches.


Where is the odometer cable in a 1996 Chrysler town and country?

A 1996 Chrysler Town and Country does not have a speedometer or odometer cable. That signal comes from the transmission output speed sensor.