Acura Legend
Timing Belts and Chains
Ford Ranger XLT
Chevy Trailblazer

How do you change the timing belt on an 1990 Acura Legend?

252627

Top Answer
User Avatar
Wiki User
Answered
2015-07-15 21:06:28
2015-07-15 21:06:28

first you should have your car lift up. first you will have to take the wheel off so you can get to the crank pulley you will have to take it out. after that you might have to lift the engine up a little so you can take the black cover off then make sure you mark the time that is in mark it with something so later you can put it exactly the same way.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The transmission filter is not in the pan like most other vehicles. On a 1990 acura legend it's an inline filter kinda looks like a fuel filter but located by the radiator.

I used Valvoline VV155 MaxLife SAE 5w30 Motor Oil in my 1990 acura legend

Some parts are, the 2.7liter is but some of it's electrical components are not

same as the front brakes they r both disc brakes

If timing is bad on a 1990 Acura Integra they car will either run incredibly rough out not at all. To fix the timing be sure to correctly align the distributor to the right factory specified degree.

Remove the belt from your 1990 Acura Legend alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.

its probably the main relay that needs to be replaced

Vegetable Oil for the rice burner.

Sure it is!.. I have a 1990 Acura Legend, and they are very reliable vehicles, I would just look into the Vehicles history, and the maintenance upkeep on the car..

you need a special tool called a t wrench

timing belts on Honda and acura motors should be changed every 70,000 miles, otherwise you run the risk of the belt breaking and bending valves

From my research, as an owner of a 1990 Ford Tempo GL, there is no timing belt.

it has a timing chain, not a rubber belt. no need to change unless necessary

i had a 1990 acura legend my blower motor was located under the passenger side dash board

ecm is under passenger footwell under carpet or under seat.coupe or sedan!!!!

how do you replace an alternator on a 1990 integra

The 1990 2.4L 4cyl mighty max has a timing BELT. Very easy to change.

the water pump belt is your timing belt under the timing belt cover

press both buttons at the same time, it will start blinking, set it then.

the EGR valve is just under the distributor cap

The new hood will fit as long as its between 91-95 and if you have a coupe the hood needs to be from another coupe, the sedan hood will not fit on the coupe or vice/versa. Hope this helps!

You need to specify what 1990 Acura are you swapping an NSX motor into.

Find the hood control on the driver side of the car or try working the hood latch.

it on the left side of the tranny pan, behind the front driver side tire


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.