You drain and refill at the transmission from underneath the vehicle.
Yup, the bell housings are exactly the same.
how the transmission module works
No because the driveshaft and transmission are diffent sizes.
Yes it will fit in but it will not bolt up to transmission
All starters on 240sx are located on the transmission. plain and simple with two long bolts.
No. The sentra is front wheel drive, the 240sx is rear wheel drive.
take out the halfshafts pull the motor and unbolt the tranny
The Nissan 240SX was brought to America in 1989.
NO, bellhousings are different.
all newer models take Dexron III transmission fluid
To change the bellows on a 1993 240SX Nissan you will need to jack up the car and start by removing the shocks. You may want to hire a mechanic to do this as a functioning set of brakes is very important.
When lube runs out the fill hole it is full.
It should be on the right hand side towards the front
Yes it is, the Nissan 240SX was assembled in Japan and brought to America in 1989.
Driver window is out of alignment on a 95 Nissan 240sx? what do i do
Nissan J-Matic Dexron 3 is also specified
Nope, different body styles
Rev match better, your synchros are worn out. Your transmission needs a rebuild.
Wat are the tps volt settings for a 1992 Nissan 240sx
nissan 240sx. it turns over but wont start
It's on the side of the transmission, had 2 wires and looks like a little black cylinder.
yes it will with the correct engine mounts, cross member and loom
no different door the 93 will fit small on the 95
BY getting an Honda all your problem will go away Aman.
On the Nissan 240SX the electric overdrive switch is located on the right side of the transmission. Overdrive allows shifting into the auto's fourth gear.