The clutch fluid container is on the right of the engine bay. The container will have a mark molded into the side of the container, or a dip-stick attached to the lid. Confirm that the level of fluid is above the mark.
There should be a reservoir near the brake master cylinder reservoir. Normally its located on the drivers side rear of the engine compartment.
The clutch cylinder on a 1994 Acura Integra is bled by placing a tubing on the slave cylinder bleeder valve and placing the other end underneath brake fluid. Pump the clutch pedal several times and hold it down. Release the bleeder valve. Keep doing this process until bubbles no longer exit.
don't know wat kind of fluid it takes 91acura integra ls
10w40 4.8 pts.
Dexron II ATF
in the engine
Usually thru the dipstick hole!
At the power steering reservoir.
8lts i think
The manual that came with my 1990 Acura Integra GS indicates to use Dexron II. If you change the fluid only it's 3.2 qts. I hope this answers your question.
There is a fill hole in the side of the transmission towards the middle facing inward. The fluid should be just high enough to not run out of the hole.
A 1999 Acura Integra LS takes approximately 2.5 quarts of transmission fluid in order to fill it up. It is important to keep your fluids full in your vehicle.Ê