You can use Lime-away to remove mineral deposits from the outside of the swamp cooler (also called an evaporative cooler), but I think you may be asking about the mineral deposits that are on the cooler pads. New pads should be installed every year. Go to your local home improvement center to get the pads and ask for some brief instructions. It's a simple process and isn't very expensive.
A desert is cooler because of the loneliness outside
It is a function of the "dew point" of the air at any given moment. If relative humidity is high, the dew point will also be high and the swamp cooler air will be relatively warm. If relative humidity is low, the dew point will also be low and the swamp cooler air will be relatively cold. A swamp cooler in Phx AZ will put out air about 30 degrees less than the outside air, and works more efficiently when the humidity outside is very low.
The odor from a swamp cooler is generally caused by bacteria and/or mold, which tend to make it smell like, well, a swamp. Drain it, clean it thoroughly with a disinfectant/deodorizer (and possibly replace the pads if they're really nasty), and when you refill it and start it up again it should smell better.
replacement bearing cooler
form_title=Swamp Cooler Installation form_header=11553 Please specify the type of space the swamp cooler will be used in.*= () "Single Family Home () Mobile Home () Garage, warehouse, etc." Where would you like the swamp cooler installed?*= () Roof () Wall () Window () Attic Can you explain how the swamp cooler will be regulated?*= () On/off switch () Thermostat () Want recommendation What number of rooms would you like the cooler to be connected to?*= {Select One,1,2,3,4,5,6,7,8,9,10 or more}
Put a lot of copper pennies in your swamp cooler. The copper will kill the mold using IONs or something.
YES! CLR can clean anything, darling. I promise, you will NOT be disappointed. But on the commercial, the shower drain thing, not true. It doesn't happen just like that.
Home windows do have to be open when you are using a swamp cooler. You do not open them all the way, they should be opened part way.
the best thing for a swamp cooler leak, is a copper pipe, or plumbing sealant, its similar to jb weld, only its waterproof, and made for leaks.
Yes, it is recommended to leave windows open when using a swamp cooler. This allows for proper circulation and ventilation, as the cooler draws in fresh air from outside. Keeping windows open also helps to prevent the air in your space from becoming too humid.
Its not the air thats slow its you
There should be one near to the input power connection.