answersLogoWhite
Nissan Altima
Toyota 4Runner
Ford Explorer Sport

How do you clear the diagnostic code on a 1995 Nissan Altima?

232425

Top Answer
User Avatar
Wiki User
2010-03-13 19:04:34
2010-03-13 19:04:34

small panel on right side of gas pedal pull it off computer is silver box look for flathead screw turn on ignition (dont start) turn screw all the way counter clockwise and then clockwise turning screw from one stop to the other be sure that you completely turn it both ways until it stops or computer might just do a self diognostic test but not reset any codes

1

Related Questions

User Avatar

how do you reset the oil light on a 2000 altima

User Avatar

No its completely different.You can see the difference at jlkautoparts.

User Avatar

You can fix black smoking on a 1995 Nissan Altima GXE 2.4L by replacing its catalytic converter.

User Avatar

Two drive belts on the 93-97 altima 2.4.

User Avatar

How to deactivate an anti theft system from a 1995 Nissan altima gxe

User Avatar

Never. 1995 Nissan altimas have 2 timing chains. Not belts.

User Avatar

how do you replace the ac evaportator

User Avatar

Nissan recommends 5W/30 Engine-oil for Nissan Altima (same as for Maxima) for 95, 96, 97, ... later years.

User Avatar

yes 93-97 as long as there is not a difference in abs or limited slip diff

User Avatar

The 1995 Nissan Maxima computer diagnostic plug can be found on the bottom of the drivers side dashboard. The computer diagnostic plug will be on the right hand side of the steering column.

User Avatar

I don't believe that the altima had a crankshaft position sensor until 1995.

User Avatar

I don't believe that the altima had a crankshaft position sensor until 1995.

User Avatar

Yes, with a tow dolly or car trailer.

User Avatar

Check the transmission fluid on the 1995 Nissan Altima. Bad fluid can cause the transmission to shift harder on parts that are more worn.

User Avatar

I don't believe that the altima had a crankshaft position sensor until 1995.

User Avatar

The 1995 Nissan Altima was equipped with the 2.4L 4-cylinder. Oil filter part numbers by manufacturer are Ford Motorcraft FL389, Denso 1501007, and AC Delco UPF1232.

User Avatar

The 1995 Nissan: temperature sensor is located on the front of the engine. The coolant temperature sensor will be near the thermostat housing.

User Avatar

The Camshaft sensor is located under the cap and rotor of the distributor. This is a common failure on the 2.4L engine due to oil leakage into the distributor. how is the camshaft sensor replaced on 1995 Nissan altima. what other considerations are there.

User Avatar

Check this Web; http://www.installdr.com/TechDocs.html

User Avatar

Located between the passengar and engine compartment.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.