0
(1)make the transformer
R,Y,B,N terminals in GST mode.
(2)coneect insulation resistor test set to any of phase.
(3)apply high voltage to that connected phase
(4)test set will denote u the value of IR
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Is the R-value of insulation indicate resistance to heat flow?
yes the R-value does indicate resistance to heat flow
What is R factor in heat insulation?
An R-value is a unit of thermal resistance for a particular material or assembly of materials (such as an insulation panel). The R-value depends on a solid material's resistance to conductive heat transfer.
Why wood does not conduct electricity?
Wood can conduct electricity if the wood is still green or wet, otherwise the wood has too much resistance (resistance is the opposition to current flow).
Insulation products are used to do what to energy loss?
Insulation products are used to prevent energy loss. Hope it helped. :)
Difference between insulation resistance and dielectric strength?
INSULATION RESISTANCE: The insulation resistance is a measure of the capability of a material to withstand leakage of current under a Vdc potential gradient. DIELECTRIC STRENGTH: The dielectric strength is a measure of the ability of the material to withstand a large field strength without electrical breakdown, and is usually expressed in volts per mil (.001') or volts per cm of dielectric.
Why the load must be removed when to conduct the insulation and resistance testing?
explain why all the load must be removed when to conduct the insulation and resistance testing
What is difference between insulation resistance test and polarization index?
Insulation resistance test: This test is used to find the insulation resistance of motor for 1 min or 10 min through high voltage insulation tester. By this we can find the insulation level. Polarization index: This is the ratio between insulation resistance for 10 min to insulation resistance for 1 min.
What is the difference between an Insulation Resistance Test and a Continuity Test for Electric Cables?
A continuity test checks to ensure that there is no break in the conductors. An insulation test checks to ensure that the insulation is sound.
What is the difference between resistance and insulation?
Resistor is a current a insulator is a not conductive and conductors can conduct.
What type of test should a megohmmeter be used on?
Insulation resistance.
When carrying out an insulation resistance test on a walloven with mineral insulated metal sheathed heating elements the minimum permitted insulation resistance is?
0.1M ohms
Why break down occurs and getting zero insulation resistance when a megger test is performed under vacuum?
The reason why the break down occurs and getting zero insulation resistance when the Megger test is performed under vacuum is because there needs to be a full test voltage performed. Insulation resistance represents the ratio that is between the applied voltage and the leakage.
What are the test for 132 kv cable?
1. phase identification test. 2. Insulation Resistance Test. 3. Conductor capacitance. 4.Conductor Resistance. 4. Outer Sheath Test.
What are the test carry after house wiring?
earth fault impedance test,very important to proper operation of protection system then insulation tests in conduits insulation test of switches resistance test of cables. polarity tests in switches
Why multimeter cannot used for measurement of insulation resistance?
Because ordinary ohmmeters are calibrated to measure a range of resistance values that are significantly lower than the resistance of insulation. It should also be realised that we usually test insulation resistance while subjecting the insulation to a high electric field, which a normal ohmmeter is incapable of producing.
What test would identify a short circuit in a lighting circuit?
earth continuity insulation resistance polarity
What is isolation resistance?
I think you mean, 'insulation' resistance! It's the resistance of insulation, normally expressed in megohms.
