well it depends on what type of remote control your using...
Wires and stuff. lol.
What it is, is your power ant. wire is hooked to your remote(control) wire of the Amp.To fix this disconnect it and connect it to the remote(control) wire. If you dont have a output labeled as this connect it to the hot wire for the radio. (do not connect it the the constant hot wire there will be two different wires)
Wiring installation means that something must be connected to a remote power or control source using wires. It more difficult to install than wireless but can result in better overall performance.
A remote control is used to control an electronic device form a distance without wires. It uses infrared or radio frequencies to transmit the data to the device.
Not usually, remote control may be via wires, hydraulic, radio waves or smoke signals, Radio control refers specificaly to items controlled by radio.
I connect my wires to the fog lights connection, that way I had control from inside the car to turn them on or off.
Run your power, ground, and remote wires. Then connect your RCAs to the back of your CD player and your amp, then connect your speakers to the amp..-Shocker
I'd suggest using a wire nut.
There are a few differences. Radio controls use radio waves and reach a longer distance. Remote controls usually use infrared or bluetooth and are usually for only short distances.Remote control means (roughly speaking) remotely controlling a device using something that is not part of the device itself. The controlling device can be attached to the device using a wire or wires to transmit controlling signals. It can also be unattached with control signals being transmitted using radio signals, or light waves (infrared, ultraviolet). A more sophisticated device can also use standard network communication protocols along wires or WIFI or Bluetooth for communication and control.Radio control is remote control using radio transmission.
No wires are needed at all, simply connect to the PSN using a wireless internet connection, games can be downloaded here after you buy them.
The central locking is controlled by an electronic device called the central locking control unit that is bascially a relay. There are normally 4 wires that go to each door. Two of the wires connect to the lock mechanism and tell the central locking control unit whether the doors are locked or not. The other two wires connect to the actuator which can either take the form of a motor or an electro magnet. The Central locking control unit connects these wires in one direction to lock and the opposite direction to unlock the doors. Most modern cars also have a remote sensor that detects the signal from a remote key fob. This send a radio or IR signal to a detector which then connects to the central locking control unit to tell the car to lock or unlock. This uses a coded signal that is unique to that particular key fob.
To connect your wires from a sound system running throughout a building to an iPod docking system, it really depends on the type of wires you are using. You might be able to use a coupler to connect non RCA wires.