answersLogoWhite

0

Disconnect the battery and the wire has a conector on it . undo clip and slide apart .

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

How do you reset air bag light on a 2003 Toyota Corolla?

my2003 toyota corolla the airbag light is on


Where is the airbag module located in a 2006 Toyota corolla?

look for places that say airbag


How do you reset the airbag light 2003 Toyota corolla?

Probably the best way would be to disconnect the battery for about 30 seconds or so. That usually clears any "codes" in the computer. It does in my car anyways.


How can you reset the airbag light on a 1993 Toyota Corolla?

You will first need to check that the airbag has been properly set up. Then you can go into your settings and get it all reset.


Where is the airbag control module located on a 2003 Toyota corolla?

center of the steering wheel, under the horn cover


Will a 2007 Toyota corolla stall if airbag light is on?

The airbag light being on in a 2007 Toyota Corolla typically indicates an issue with the airbag system, not the engine. While it can signal other electrical problems, it does not directly cause the vehicle to stall. Stalling is usually related to engine or fuel system issues rather than airbag malfunctions. If your car is stalling, it’s advisable to check the engine and related components.


Where is the airbag brain located on a Toyota Corolla?

Somewhere above the driver's seat, and below the ceiling, depending on the height of the driver.


What does it mean when your airbag light comes on on your Toyota Corolla?

It means it needs to be serviced at the dealer. The integrity of this device is now questionable and probably will not protect you adequately in a crash where the airbag gets deployed.


How do you shut off air bag warning light on a Toyota corolla?

To turn off the airbag warning light on a Toyota Corolla, first, ensure that there are no issues with the airbag system by checking all connections and sensors. If everything appears normal, you can reset the light using an OBD-II scanner to clear any diagnostic trouble codes. Alternatively, disconnect the vehicle's battery for about 10 minutes, then reconnect it to reset the system. If the light persists, it's advisable to consult a professional mechanic for further diagnosis.


How do you disengage a seat belt sensor for a 2005 Toyota corolla?

Not sure if the 2005 is the same as the 2006 model but the only way I know is to disengage both airbag plugs under each seat. No beep but also no airbag.


How do you turn off the passenger side air bag on your 2005 toyota corolla?

To turn off the passenger side airbag on a 2005 Toyota Corolla, locate the airbag switch, which is usually found on the side of the dashboard or the passenger side door's jamb. Use the vehicle's key to turn the switch to the "Off" position. Ensure you check the dashboard indicator light to confirm that the airbag has been successfully disabled. Remember to turn it back on when a passenger occupies the seat for safety.


How can I temporarily disable the airbag in my 1994 Mercury Sable Sedan so that I can safely install a new audio receiver?

disconnect the battery.