How do you drain coolant from engine block on Nissan Quest 2001?

If you mean the engine coolant temp sensor it should be on the drivers side of the engine block. Follow your top radiator hose from the radiator to the engine block. near that you should see a sensor (it has a clip on it where the wires attach). I hope my description helps!

Where is the coolant drain plug on the engine block for an 02 Tacoma Prerunner?

The 2002 Tacoma engine block will have two coolant drain plugs on each side of the block. The coolant drain plugs will be near the front and the rear of the engine block.

Where is the engine block coolant plug on a Jeep Cherokee?

The engine coolant block on a Jeep Cherokee has two block coolant plugs. There is one on each side, next to the freeze plugs.

Where on the engine block of a 1987 Nissan maxima are the coolant system drain plugs and after you flush the system do the drain plugs have to be replaced?

Ive never heard of draining coolant plugs except on a diesel engine . Once you drain the coolant and flush the system it should be fine

Where is engine block drain plug for coolant on 1994 Lincoln town car 4.6l engine?

The 1994 Lincoln Town Car 4.6 liter engine coolant drain plugs can be found on each side of the engine block. There will be a total of four engine coolant drain plugs.

Where is the engine block coolant plug on 6-cylinder?

The engine block coolant plug on a 6-cylinder is near the bottom of the engine. You will need to use a socket set and ratchet to remove the plug.

Where is the engine coolant sensor in a 1998 Saturn SC1?

I believe it is on the block where your engine coolant runs into the block from the radiator. There should be two wires that run to a plastic-like sensor.

Do block heaters and coolant heaters work the same?

yes in a way. block heaters heat the coolant in the block there for warming the block up. coolant heaters heat the coolant out side the engine like in the hoses and radiater. and when the coolant gets hot enough it opens the thermosate and starts flowing through the engine..The coolant heater should be hooked into the engine so that it heats only the engine and the heater core. If the coolant heater is trying…

Coolant flows from the engine block into the through the coolant jacket?

Kind of. There are water jackets inside the engine block and usually the heads of a liquid-cooled engine Water (or coolant) will either flow from the block to the head to the radiator, or from the radiator through the head to the block (a reverse flow design). The latter is better because it cools the heads first and helps prevent detonation. It also reduces thermal shock to the engine block.

Does coolant drain on engine block need a special wrench on a 2002 tundra?

There should not be a coolant drain on the engine block. You are probably looking at a freeze plug which should NOT be removed. The freeze plugs where openings for the original production/casting of the engine block and are sealed.

Is thermostat important in a car?

Yes, it controls the coolant flow around the engine block, without coolant the engine would overheat.

Need to drain the engine coolant where are the engine plugs on a 1990 ford Ranger?

You drain coolant from the radiator. but according to the book ther are two plugs on the engine block that need to drain the coolant from.

I need to drain the engine coolant from the engine block on a 1997 transport. Where is the engine drain plug located?

on the buttom of the block Can you please be more specific? Where exactly on the bottom of the block? Near what on the block?

Where is the Engine block coolant drain plug on 1997 z28?

The coolant drain plug is located on bottom corner of radiator facing engine.

How to install Engine block heaters?

block heaters are kinda hard to install. you would have to drain your coolant and take out one of the freeze plugs. that's were the block heater gets put in to warm the coolant in the block.

What is the purpose of an engine block in the context of a car?

An engine block is used in cars to support the components of an engine. It is also used to transfer heat from friction to the atmosphere and engine coolant.

What is the cable with a wall plug in on it on engine of a 2002 Chrysler Sebring?

That is an engine block heater. It heats the engine coolant.

How do you flush the coolant?

Take it to dealer and hope they do it correctly, There is a plug on bottom of radiator loosen and it drains coolant out of radiator, but not out of engine, There are plugs on the side of the engine block that have to be removed to drain coolant out of block. Probably impossible to get to and accidents happen, sorry I hope this helps some.

Where is the engine block coolant drain plug located on 2000 Chevy s10 four cylinder?

Rear of the engine block, near the oil pan.

Where is the engine coolant petcock on a 1996 350 Chevy Tahoe engine?

The engine block coolant drain plug on a 350 Chevy Tahoe is above the oil pan, mid engine on driver's side

How do you chang a thermostat on a 2000 Nissan Maxima?

You need to first drain the coolant, to lessen the mess of spilt coolant. Next you have to unbolt the coolant neck at the block to access the thermostat. After replacing, you have to refill/bleed the coolant system.

How do you install block heater 2005 Chevrolet optra?

drain coolant from radiator, remove one of the frost plugs in engine block, install block heater in place of frost plug, refill radiator with coolant.

Where is the coolant temperature sensor on a BMW 325?

under the manifold on your engine block.

Is the coolant drain on the radiator or on the engine block?

Most vehicles have a drain on both.

Where is the coolant temperature sensor1991 beretta?

On the engine block, near the thermostat housing.

Where is the coolant engine block drain plug on a 2005 Silverado 5.3?

On either side of the engine block. It will require a 6 point 13mm socket to remove it.

Why would heat turn to cold when you slow down on a 2002 Nissan sentra?

Check the radiator coolant level! When it is low, and RPMs decrease at low speeds or idle, the coolant isn't being circulated through the entire cooling system, such as the heater core! Be sure the engine is cool before opening the radiator cap and adding coolant! NEVER add coolant to a hot engine because it will crack the block or cause the head gasket to blow!

Does water stay in engine block when car's not running?

Yes, coolant is in the block, heater, hoses and radiator all the time.

How does antifreeze help you in your engine block?

Antifreeze helps by not allowing the coolant to freeze and possibly crack the water passages of the block.

Where are the engine block coolant drain plugs on a 1998 buick lesabre 3.8 engine?

its at the bac of the engine under the cooler cables

Why would you only get 2 quarts of antifreeze out of your radiator when there is supposed to be 11 quarts of fluid in the system?

Np, because most of your coolant is contained in the engine block. So when you drain your coolant from your radiator, most of the coolant will *remain* in the block.

Where is the starter located on a 1988 Nissan Stanza?

The starter on a 1988 Nissan Stanza can be found on the inner side of the engine. It is between the gear box and the engine block.

Where is the block heater cord for Nissan Murano?

The block heater cord on a Nissan Murano is located along the right side of the engine near the oil dip stick. It attaches to the block via and anchor bolt and slowly warms the engine during extreme cold weather.

How do you get the water out of the engine block for a Chevy Blazer?

Assuming this is a 4.3 engine, remove the block coolant drain plugs. There is one on each side of the block. The passenger side is towards the front of the block and the drivers side is towards the back.

Where is engine number for Nissan Pathfinder 2001 model located?

The 2001 Nissan Pathfinder engine number can be found on the engine identification plate. The engine identification plate should be attached to the right side of the engine block.

Where is the oil filter on a 1999 Jeep Cherokee?

Find the Engine Coolant tank on the front passenger side of the engine bay. Look straight down into the gap/space between the Engine Coolant tank and the main engine block. You will see a small tube-shaped oil filter sticking out from the bottom of the engine block area. On the 4.0L it is on the passenger side of the middle of the block. On the 4.7L it is on the driver side front of the…

Where is the coolant temperator sensor 1991 berretta?

On the engine block, near the thermostat housing.

Where is the coolant temperature sensor for the computor1991 beretta?

On the engine block, near the thermostat housing.

Where is the thermostat on a 1989 Buick reatta?

right where the coolant hose enters the engine block

Where is the coolant temperature sensor located on a LS1?

On front driver's side of engine block.

What does it mean when the engine is leaking coolant from both sides?

Check the freeze plugs. large round plugs on either side of the block. Those are there for if your coolant freezes, they will go instead of cracking the block.

Where is engine block heater on 1996 Nissan Pathfiner?

it is where the frost plug is normally

Where are the head gaskets in a Nissan Altima?

Sandwiched between the heads and the engine block.

Can you smell a coolant leak at the head gasket?

The head gasket sits between the head and the engine block if it is leaking out where you can see the coolant, yes you can smell the coolant if it is leaking into the engine no you cannot smell the coolant. You can check the oil to see if it has coolant in the oil if it does then the head gasket might be blown.

Where is the block heater in a 2003 Mazda Protege?

Right Rear of engine block. Above Alternator, Below coolant drain plug

How do you get rid of the brown water in your radiator?

If your coolant is brown, this means it has LOTS of rust in it. If this is the case, then you need to flush your cooling system and refill it with fresh coolant. Be sure to drain your engine block as well as your radiator, as MANY people neglect to do this. Without draining your engine block, you are basically just changing half your coolant.