The way to drain gasoline from a Briggs and Stratton lawn mower is to take the oil cap off and drain the oil. From there, run a rubber hose into the drain and siphon the rest of the oil and gas out.
One can purchase parts for a used Briggs and Stratton lawn mower from the following sources: Mower Graveyard, eBay, Briggs and Stratton, Zangler Repair, Lowes, Discount Online Parts.
Where is the location of the idle screw on the Briggs and Stratton 6.0 engine mulcher mower?
0.030 is the gap for briggs and stratton 4.5 hp mower
Briggs and Stratton does contract anyone to build mowers. The mower manufacturers contract Briggs and Stratton to build their engines (or whatever engine is on the unit). That is why you can have a Briggs and Stratton on most any type of mower. Same is true for Kohler, Tecumseh, etc. Not to say that the engine manufacturers do not build their own type of outdoor power tool but as the question states "snapper mower". Also keep in mind that if you have a snapper mower with a Briggs and Stratton engine and you need warranty work on the engine you need to go to an Authorized Briggs repair facility where as if you have a mower warranty then you need to go to an authorized repair facility for the mower manufacturer.
underneath where the blade is you will see a plug. that's it
Briggs and Stratton and Kohler engines are considered quality components. Neither is likely to be better. However, the Briggs and Stratton brand is more popular.
You can find the operator's manual for that engine at www.briggsandstratton.com. You will need to contact the manufacturer of the mower for the lawn mower owner's manual. Briggs and Stratton did not amke that mower, only the engine.
It is a 2-cycle 4HP Briggs motor.
Briggs and Stratton is a select brand of lawn mower. When oiling one's Briggs and Stratton lawn mower engine, it is best to use a high quality oil. One can find such an oil at their local home improvement store, such as Home Depot.
a manul to show me the way to do it
Brigg's and stratton 5.5 hp on the craftsman push mower your gap tool set the gap at .025-030 for briggs 5 hp
It is either on the side of the engine at the very bottom next to the deck, or it is under the mower on the engine block.
Briggs and stratton engines use different oils depending on the temperature to which the engines will be used. Generally sae30 oil should be used for mower engines
Assuming you are talking about lawn mower engines, it is located on top of the gas tank. The gas tank is of course where the gasoline is poured into.
4.5 mower will start and run for two seconds
go to briggsandstratton.com
You should always have 20 fluid ounces of oil in a Briggs and Stratton 5.5 HP lawn mower. This equals out to roughly 1.6 quarts.
you can goto briggsandstratton.com and get a manual for that engine,
yes B&S labels oil
SAE30 is used in most Briggs and Stratton engines.
SAE 10w30 Synthetic.
there should be a drain plug under the mower where the blades are. to fill it is on the top where you check the oil. there is a drain plug under the mower where the blade is. to fill it is where you chech your oil. Many mowers do not have a drain plug, simply remove the dipstick and tip the mower on its side and dump it out the filler tube into a proper container.
not getting fire 4.75 briggs statton lawn mower
Check the underneath of lawn mower for grass built up.
Asked By Wiki User
Copyright © 2021 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.