Use "prompt $p$g" command.
exit
press the 'x' in the corner. Type in the word exit.
Type exit to close the Command Prompt window, or click the red X in the corner. To shut down your computer, type shutdown -s
Just run "exit" command.
Safe mode with command prompt option is totally depends on DOS shell, hence there is no need for separate command prompt..
1. Open an elevated Command Prompt window. To open an elevated Command Prompt, click Start, click All Programs, click Accessories, right-click Command Prompt, and then click Run as administrator.2. Type the following command and press ENTER:rd /s /q C:\$Recycle.bin(This clears out the $Recycle.bin folder for the C:\ drive. You may have to do this for each hard disk partition in your system.)3. Type exit to close the Command Prompt window.
when using command prompt, after you give it a command, press the enter button. Command prompt will then carry out the task and will automatically go to the next line.
PROMPT command is an internal command, which is used to change the MS-DOS prompt. Through, the system displays the prompt bu default, when you start the computer.
In command prompt write "ipconfig/all" command and then press [enter]. And see the IPv4 Address section in the commend prompt.
when you are in cmd command prompt "type" help and you will see all the codes
To clear the Command Prompt window, enter CLS
when you are in cmd command prompt "type" help and you will see all the codes