If one of the turbine speed sensors is malfunctioning locate the broken part must be found. This is done by using a diagnostic machine. A broken sensor will need to be replaced in order for the components to work correctly.
YOU HAVE TO DRIVE IT TO HELL AND BACK Most likely either the wires to the vehicle/turbine speed sensor are broken or the vehicle/turbine speed sensor is defective
Engine speed sensor circuit malfunction.
P0720 Output Speed Sensor Circuit Malfunction
Code 0715 is for an input shaft speed sensor circuit malfunction. Changing the speed sensor out for a new one should fix the issue.
get a new cam position sensor (about $35)
Replace the downstream O2 sensor
Code P0715 is triggered when the transmission's Input Speed Sensor isn't providing a reliable signal. Common Problems are a defective input/turbine speed sensor, defective shift solenoids, a defective engine coolant temperature sensor, a defective valve body, or dirty transmission fluid that restricts the hydraulic passages.
Trouble code P1120 means: Accelerator Pedal Position Sensor Circuit Malfunction replace APS sensor Trouble code P01135 means: Air-Fuel Sensor Heater Circuit Response Malfunction
circuit means in that loop which can be crankshaft sensor, cam shaft sensor, or timing chain or belt what ever you car has hope this helps
O2 sensor heater circuit malfunction (bank 1 sensor 1). You probably have a burned out Bank 1 Sensor 1 O2 sensor. Also check the wiring at the sensor for damage.
Trouble code P0700 means: Automatic Transmission Control System Malfunction Trouble code P0720 means: A/T Output Speed Sensor - Low Output Above 15 MPH Replace the speed sensor and erase codes that should fix it.
DTC P0141 is: Oxygen Sensor Heater Cuircuit Malfunction (Bank 1 Sensor 2). The Downstream O2 Sensor(aft of the Catalytic Converter) most probably need to be changed.....