Geo
Chevy Silverado
Chevy S-10
Grand Am GT

How do you fix a Geo electronic spark control?

535455

Top Answer
User Avatar
Wiki User
2006-09-25 01:47:00
2006-09-25 01:47:00

hi there if i remember the distributor is troublesome and you have to replace the whole thing

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Electronic Spark Timing (EST) bypass circuit or EST circuit is grounded or open. HEI Module may be the cause

User Avatar

coil, wire, ignition control module

User Avatar

Repair kit availale at most auto parts stores

User Avatar

I have a 92 s10 blazer and my code 43 was fixed by replacing the knock sensor. so maybe check the knock sensor and the wiring from that to the ECM.

User Avatar

Code 43 = Electeroic Spark Timing (EST) circuit low voltage detected OR ESC circuit problems. Without being there to put a meter on different components and check it out, all I can do is point you to the electronic spark control module.

User Avatar

You will need to remove the dashboard panel in order to replace the electronic throttle control light. With the dashboard panel removed the light can be access to be replaced.

User Avatar

I would replace the ignition control module that's in the distributor.

User Avatar

You replace it you do not fix it.

User Avatar

You need to have the system checked for codes. You can then diagnose and find and repair the cause.

User Avatar

Electronic Spark Control Code 43 Speed density 1990-92 Hope this helps, jr Yo go to chevythunder.com dude, you'll find more than you'll ever need

User Avatar

You don't fix it, you replace it.

User Avatar

Replace the ignition module. It under the rotor under the distributer cap Held on by two 5.5 mm head bolds and make sure you use new di-electric grease or the new one will burn out FAST

User Avatar

only way to fix a spark plug is to replace the problem plug with a new one

User Avatar

Check coolant level? Bad thermostat? Heater core airbound? Temperature control cable not adjusted properly?

User Avatar

It sounds like you need to replace the crankshaft position sensor! If it is bad you will not get any spark.

User Avatar

You must first find out why you do not have spark. Then you can fix the issue.

User Avatar

The first step is have the system checked for trouble codes. The cause will be the main factor in the repair.

User Avatar

Try moving it a little closer to the metal at the end of the white porcelain piece, it may be too far away to make a spark.

User Avatar

my car no start I check the spark ignition on the wires an they don't have how can fix the problem....

User Avatar

That depends on what it is doing or not doing.

User Avatar

You have to take it apart to determine what is wrong before you can fix anything.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.